Side return extension steels · Craigavon
Side return extension steels in Craigavon
Side return extension steels in Craigavon, from free survey to completion certificate.
- Survey, design and installation in one
- Covering BT63, BT64, BT65
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Side return extension steels in Craigavon: how it works
Side return extension steels in Craigavon are planned around the house, not a standard kit. Our coverage runs across Armagh City, Banbridge and Craigavon, so nearby villages are included too. We visit, measure and check what the wall carries, then arrange calculations and building control approval before any steel is ordered.
Many Victorian and Edwardian terraces have a narrow back wing, often called an outrigger, with a strip of yard down one side. Infilling that strip turns a galley kitchen into a wide family room, but the outrigger's side wall usually holds up a bathroom or bedroom above, so it has to be replaced with steel.
What to expect
- The side wall of a typical outrigger carries the first-floor wall above it, and sometimes the rear wing's roof and the joists of the room over the kitchen. That is why taking it out calls for a beam along its full length.
- Bathrooms above outriggers are common, and their floors carry baths, tiles and water. The engineer allows for those loads, and any soil pipe or waste running down the side wall is rerouted before the wall comes out.
- Victorian outrigger walls are often a single brick thick in soft lime mortar, sometimes on very shallow footings. The engineer may ask for trial holes before deciding whether new foundations are needed under the column positions or beam ends.
- Fitting the steel frame for a side return usually takes a few working days on site, depending on how many beams and columns there are. It is scheduled with the builder so the new space can be roofed and weathertight soon after the old wall comes down.
- The kitchen is usually out of use while the side wall comes down and the frame goes in, so many households set up a temporary kitchen elsewhere in the house. The rest of the property normally stays in use throughout the steel stage.
How the job runs in Craigavon
Survey in Craigavon
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
A full plans application or building notice goes to Armagh City, Banbridge and Craigavon Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for side return extension steels in Craigavon
As a guide, budget £3,000–£7,300 including VAT for side return extension steelwork in Craigavon, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Side return extension steelwork | £3,000–£7,300 | Beams and posts along the old side wall line, propping and approvals (extension build extra) |
| Steel column or post | £430–£1,290 per column | Column supplied and fitted with base and cap plates on a pad foundation |
| Opening into a rear extension | £2,150–£6,000 | Original rear wall removed with a beam or goalpost, approvals and propping, coordinated with the extension build |
| Fire protection to a steel beam | £130–£520 per beam | Fire-rated board boxing or an intumescent coating system as specified |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building control and neighbours in Craigavon
Removing a load-bearing wall in Northern Ireland needs building control approval from the council. Armagh City, Banbridge and Craigavon Borough Council covers Craigavon. The engineer's calculations support the application, and a completion certificate is issued after the final inspection.
The Party Wall etc. Act does not extend to Northern Ireland. Shared walls are dealt with under your title and the general law, so we recommend agreeing access and the work with your neighbour before it starts.
Side return extension steels in Craigavon: your questions
How much do side return extension steels cost in Craigavon?
As a guide, budget £3,000–£7,300 including VAT for side return extension steelwork in Craigavon, based on published UK cost guides adjusted for prices in Northern Ireland (-14%). The exact figure depends on the span, what the wall carries, access and the finish, and is fixed in writing once the scope is agreed.
Can I stay at home while the work is done in Craigavon?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.
Can the outrigger wall be removed without affecting the bathroom above?
Yes, when it is properly propped and replaced with steel designed for the load. The floor and wall above are supported throughout, and the bathroom stays usable in most cases. Waste pipes or soil stacks on the wall being removed are rerouted first so nothing is disturbed when it comes down.
Why does a side return need columns?
Columns are used where two beams meet or where there is not enough solid wall to carry the end of a beam. The column takes the concentrated load down to a pad foundation in the ground. Sometimes it can be hidden in a wall nib or boxed in neatly.
Do I need planning permission for a side return extension?
It depends on the house and where it is. Some side return infills can be built under permitted development, but the rules for side extensions are restrictive, and conservation areas and listed buildings add further controls. Check with your local planning authority or architect before committing to a design.