Steel beam replacement & repair · Craigavon
Steel beam replacement & repair in Craigavon
Steel beam replacement & repair for homes in BT63, BT64, BT65, designed by a structural engineer.
- Survey, design and installation in one
- Covering BT63, BT64, BT65
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Steel beam replacement & repair in Craigavon: how it works
We carry out steel beam replacement & repair in Craigavon, covering the BT63, BT64, BT65 and BT66 postcode districts. The wider Armagh City, Banbridge and Craigavon area is covered as well. The job starts with a free survey visit so the engineer's calculations are based on your actual walls, floors and loads.
Not every steel beam was put in properly. Some were fitted decades ago without calculations, some sit on crumbling brick or timber packing, and some have rusted where water reached them through a leaking roof, a shopfront or a damp wall. Cracks in the plaster above, doors that stick or a visible dip are common warning signs.
What to expect
- Shop beams over old shopfronts are a common repair job. They often carry the whole front wall of the upper floors, sit behind fascias where rain gets in, and may have been cut or altered when shopfronts were replaced in the past.
- Replacing a beam that is already carrying load is more delicate than fitting a new one. Props go in on both sides before anything is cut, with spreaders above and below, and the old steel is often cut into sections to lift it out safely.
- Repairs are usually more contained than a new opening because the room layout stays the same. The main disruption is stripping the boxing, propping the floor above and the dust from cutting steel, with the ceiling and walls around the beam replastered afterwards.
- A proper assessment means opening the boxing at the ends and along the span so the engineer can see the steel. In buildings from before 2000, old boxing can contain asbestos insulating board, so it is checked before anyone cuts into it.
- Older beams were often left with no fire protection or boxed in ordinary materials. When a beam is repaired or replaced, the fire protection is brought up to what the engineer and building control specify, commonly fire-rated plasterboard or intumescent paint.
From survey to sign-off in Craigavon
Look and measure
We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.
Design and price
Calculations come back from the engineer and we confirm your fixed written price, line by line.
Building control
A full plans application or building notice goes to Armagh City, Banbridge and Craigavon Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Fit, inspect, finish
The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.
Guide prices for steel beam replacement & repair in Craigavon
As a guide, budget £1,700–£4,750 including VAT for steel beam replacement in Craigavon, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Steel beam replacement | £1,700–£4,750 | Propping, removing the failed beam, new steel on proper bearings, approval and making good |
| Shop or commercial structural opening | £4,300–£12,900 | Transfer beam and columns for opening units together or forming a shopfront opening |
| RSJ supply and fit (single beam) | £690–£2,150 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
| Structural calculations for a beam | £220–£640 | Site measure or photos, beam and padstone design and calculations for building control |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building control and neighbours in Craigavon
Removing a load-bearing wall in Northern Ireland needs building control approval from the council. Armagh City, Banbridge and Craigavon Borough Council covers Craigavon. The engineer's calculations support the application, and a completion certificate is issued after the final inspection.
Northern Ireland has no Party Wall Act, so there is no statutory notice to serve. Where the steel bears into a shared wall, the title deeds and the general law apply, and agreeing the work with your neighbour in writing first is good practice.
Local questions answered
Do I need a party wall agreement for steel beam replacement & repair in Craigavon?
There is no Party Wall Act in Northern Ireland. Your title deeds and the general law apply instead, so agree the work with your neighbour in writing before it starts.
Who approves steel beam replacement & repair in Craigavon?
Structural work in Craigavon needs a full plans application or building notice to Armagh City, Banbridge and Craigavon Borough Council. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
Why has my steel beam sagged?
A beam usually sags because it is too small for the load, the load has increased since it was fitted, or its bearings have crushed or moved. Every beam bends slightly within design limits, but a visible dip or new cracking suggests something has changed. An engineer can measure it and identify the cause.
Can you replace a steel beam without taking the ceiling down?
Usually only part of the ceiling needs to come down. The boxing and a strip of ceiling either side of the beam are removed so props can go in and the old steel can come out. The rest of the room is protected, and the disturbed area is replastered to blend with the existing finish.
Can a rusty steel beam be repaired?
Often, yes. Surface rust can usually be cleaned back to sound steel and treated with a protective coating. Where corrosion has eaten into the flanges or web, the engineer works out the remaining strength and decides whether plating will restore it or the beam needs replacing. The source of the moisture must be fixed as well.
Do you also work near Craigavon?
Yes. We also cover nearby towns including Portadown, Banbridge, Lisburn and Dungannon.