Shop & commercial openings · Solihull
Shop & commercial openings in Solihull
Shop & commercial openings in Solihull, from free survey to completion certificate.
- Survey, design and installation in one
- Covering B90, B91, B92
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our shop & commercial openings service in Solihull
Planning shop & commercial openings in Solihull? Our team covers B90, B91, B92 and B93 and the streets around them. Solihull is around 6.8 miles from Birmingham, and we cover both. You get one written quote for the calculations, approvals, propping, steel and making good.
Commercial buildings often have a flat or offices above the shop, a heavy brick front and old steel or timber over the existing shopfront. Opening them up means supporting a lot of load at street level, usually with the public walking past, while keeping disruption to trading as low as possible.
What to expect
- Shop buildings commonly have a full-height brick wall above the shopfront carrying upper floors and the roof. The engineer designs for that load, plus any point loads from chimney stacks or columns, and may specify a compound section or a steel frame.
- Supporting a shopfront means temporary works right at the street edge. Permission from the highway authority may be needed for hoarding, scaffolding or a lifting vehicle on the pavement, and props are positioned so the public route stays safe.
- Purely internal works may not need planning permission, but a new or altered shopfront changes the look of the building and may need it, particularly in a conservation area. Listed commercial buildings also need listed building consent for structural changes.
- Commercial buildings built before 2000 should already have an asbestos register under the duty to manage. Before walls or ceilings are opened up, the register is checked and a refurbishment survey of the work area is arranged where it does not cover the job.
- Where there is a flat above the shop, its occupants need to know about the works and their safety has to be protected. Their access, fire escape route and the structure holding up their floor must all be maintained throughout the job.
From survey to sign-off in Solihull
Survey in Solihull
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to Solihull Council, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for shop & commercial openings in Solihull
As a guide, budget £5,000–£15,000 including VAT for shop or commercial structural opening in Solihull, based on published UK cost guides adjusted for prices in the West Midlands (no adjustment).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Shop or commercial structural opening | £5,000–£15,000 | Transfer beam and columns for opening units together or forming a shopfront opening |
| Party wall surveyor (agreed surveyor, per neighbour) | £900–£2,000 per neighbour | Schedule of condition and award where a neighbour dissents; serving notice alone, where the neighbour consents, costs far less (England and Wales only) |
| Temporary works and propping | £150–£500 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Fire protection to a steel beam | £150–£600 per beam | Fire-rated board boxing or an intumescent coating system as specified |
Figures include our approximate regional adjustment for prices in the West Midlands (no adjustment) and are rounded. How these figures are worked out.
Building control and neighbours in Solihull
For Solihull, building control is provided by Solihull Council, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Shop & commercial openings near Solihull
- Shirley 1.6 mi
- Acocks Green 2.9 mi
- Birmingham 6.8 mi
- Aston 7.3 mi
- Bartley Green 9.2 mi
- Kenilworth 9.5 mi
Questions about shop & commercial openings in Solihull
What happens at the survey visit in Solihull?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Do I need a party wall agreement for shop & commercial openings in Solihull?
Yes, if the beam bears into a shared wall: the Party Wall etc. Act 1996 applies in England and Wales, and a party structure notice must be served at least two months before that work starts. We arrange it through a party wall surveyor.
Do I need my landlord's permission to put in a steel beam?
Almost certainly, if you lease the premises. Most commercial leases forbid structural alterations without the landlord's written consent, usually given as a licence for alterations. We can supply the engineer's calculations and drawings your landlord asks for, though the lease terms themselves are a matter for you and your solicitor.
Does the beam above my shop window need replacing?
Not always, but it should be checked. Many shopfronts sit under an old steel, timber or concrete beam hidden behind the fascia, which may have corroded, rotted or been undersized for the wall above. An engineer inspects it once it is opened up and decides whether it can be kept, strengthened or must be replaced.
Can I knock two shops into one?
Usually, yes, with the right approvals. The dividing wall is replaced with steel designed by a structural engineer, building control approves the work and the fire strategy is updated for the combined unit. You also need landlord consent if you lease either unit, and party wall notices in England and Wales if the steel bears into a wall shared with another owner.
How much do shop & commercial openings cost in Solihull?
As a guide, budget £5,000–£15,000 including VAT for shop or commercial structural opening in Solihull, based on published UK cost guides adjusted for prices in the West Midlands (no adjustment). The exact figure depends on the span, what the wall carries, access and the finish, and is fixed in writing once the scope is agreed.