Shop & commercial openings · Shirley
Shop & commercial openings in Shirley
Shop & commercial openings in Shirley, from free survey to completion certificate.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning shop & commercial openings in Shirley
Shop & commercial openings in Shirley are planned around the house, not a standard kit. It sits about 1.6 miles from Solihull, which we also cover. We visit, measure and check what the wall carries, then arrange calculations and building control approval before any steel is ordered.
Commercial buildings often have a flat or offices above the shop, a heavy brick front and old steel or timber over the existing shopfront. Opening them up means supporting a lot of load at street level, usually with the public walking past, while keeping disruption to trading as low as possible.
Key points for your project
- Many shopfronts sit under an old steel or timber beam hidden behind the fascia for decades. It may be corroded, undersized for what is above or bearing on decayed masonry, so it is opened up and checked before keeping it is even considered.
- Where there is a flat above the shop, its occupants need to know about the works and their safety has to be protected. Their access, fire escape route and the structure holding up their floor must all be maintained throughout the job.
- Purely internal works may not need planning permission, but a new or altered shopfront changes the look of the building and may need it, particularly in a conservation area. Listed commercial buildings also need listed building consent for structural changes.
- Shop buildings commonly have a full-height brick wall above the shopfront carrying upper floors and the roof. The engineer designs for that load, plus any point loads from chimney stacks or columns, and may specify a compound section or a steel frame.
- A straightforward shopfront beam replacement can take a few days on site, while joining two units with several openings may run to a couple of weeks. The programme is agreed in writing before work starts so you can plan trading around it.
Four stages, one team
Free visit
A short visit to Shirley to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to Solihull Council, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
How much should I budget in Shirley?
As a guide, budget £5,000–£15,000 including VAT for shop or commercial structural opening in Shirley, based on published UK cost guides adjusted for prices in the West Midlands (no adjustment).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Shop or commercial structural opening | £5,000–£15,000 | Transfer beam and columns for opening units together or forming a shopfront opening |
| Steel goalpost frame | £2,000–£6,000 | Two posts and a beam bolted as a frame, pad foundations, base plates and fitting |
| Steel beam replacement | £2,000–£5,500 | Propping, removing the failed beam, new steel on proper bearings, approval and making good |
| Party wall surveyor (agreed surveyor, per neighbour) | £900–£2,000 per neighbour | Schedule of condition and award where a neighbour dissents; serving notice alone, where the neighbour consents, costs far less (England and Wales only) |
Figures include our approximate regional adjustment for prices in the West Midlands (no adjustment) and are rounded. How these figures are worked out.
Building control and neighbours in Shirley
In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either Solihull Council or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Shop & commercial openings near Shirley
- Solihull 1.6 mi
- Acocks Green 2.7 mi
- Birmingham 5.9 mi
- Aston 6.7 mi
- Bartley Green 7.7 mi
- Smethwick 8.4 mi
Shop & commercial openings in Shirley: your questions
How soon can shop & commercial openings start in Shirley?
Start dates depend on the engineer's calculations, the building control approval and, where needed, party wall notice periods. We give you a realistic timetable after the survey and keep you updated as each approval comes through.
Do you also work near Shirley?
Yes. We also cover nearby towns including Solihull, Acocks Green, Birmingham and Aston.
How does fire safety change when two units are joined?
It can change significantly. The wall between the units may have been a compartment wall, escape routes and travel distances alter, and the new steel needs fire protection to the required period. Building control assesses this as part of the application, and the fire risk assessment for the premises should be updated for the new layout.
Do I need planning permission for a new shop front?
Often, yes. A new or altered shopfront usually changes how the building looks from the street, which can need planning permission, especially in a conservation area. Purely internal openings generally do not, but listed buildings need listed building consent for structural changes inside or out. It is worth checking with the local planning authority early.
Do I need my landlord's permission to put in a steel beam?
Almost certainly, if you lease the premises. Most commercial leases forbid structural alterations without the landlord's written consent, usually given as a licence for alterations. We can supply the engineer's calculations and drawings your landlord asks for, though the lease terms themselves are a matter for you and your solicitor.