Through-lounge knock-throughs · Richmond
Through-lounge knock-throughs in Richmond
Through-lounge knock-throughs in Richmond, from free survey to completion certificate.
- Survey, design and installation in one
- Covering SW14, TW1, TW2
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Through-lounge knock-throughs in Richmond: how it works
We cover through-lounge knock-throughs in Richmond (SW14, TW1, TW2) and the streets around it. Our coverage runs across London, so nearby villages are included too. Each job is designed by a structural engineer and approved through local building control before work begins.
We plan the steel so the opening suits the room's proportions and keeps period features where you want them, from chimney breasts to cornicing. The survey visit, calculations from a qualified structural engineer, building control, party wall notices through a party wall surveyor where needed, propping, steel and making good are all set out in one itemised written quote.
Things to plan for
- In most terraced houses the wall between the front and back rooms runs across the house and carries the floor above, plus the wall between the front and back bedrooms. It is normally load-bearing, but the engineer still checks before any design is drawn up.
- Period ceilings are often lath and plaster, which can crack or sag when the wall below is disturbed. Props are set to spread load gently, and damaged areas are repaired with lime plaster or overboarded, depending on the condition and your preference.
- Many owners leave short nibs of wall at each end of the opening rather than going fully wall to wall. Nibs can give the beam a bearing, line up with the chimney breasts and keep the feel of two linked rooms, but the engineer decides whether they are adequate.
- Cutting a pocket into a party wall for a beam end is notifiable work under the Party Wall etc. Act 1996 in England and Wales. Your neighbour can agree or dissent, and a dissent means party wall surveyors must set out how the work is done before it starts.
- If the house is listed, internal structural alterations need listed building consent as well as building regulations approval. Conservation area status does not usually affect internal work, but flats within converted period houses normally need the freeholder's consent.
How the job runs in Richmond
Free visit
A short visit to Richmond to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
What do through-lounge knock-throughs cost in Richmond?
As a guide, budget £3,200–£7,050 including VAT for through-lounge knock-through in Richmond, based on published UK cost guides adjusted for London prices (+28%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Through-lounge knock-through | £3,200–£7,050 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Plastering and making good | £380–£1,540 | Boxing the beam, bead and skim, reveals, floor infill where the wall stood and tidy-up |
| Temporary works and propping | £190–£640 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Kitchen-diner knock-through | £3,200–£7,700 | Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra) |
Figures include our approximate regional adjustment for London prices (+28%) and are rounded. How these figures are worked out.
Building control and neighbours in Richmond
For Richmond, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Through-lounge knock-throughs in Richmond: your questions
How much do through-lounge knock-throughs cost in Richmond?
As a guide, budget £3,200–£7,050 including VAT for through-lounge knock-through in Richmond, based on published UK cost guides adjusted for London prices (+28%). The exact figure depends on the span, what the wall carries, access and the finish, and is fixed in writing once the scope is agreed.
Who approves through-lounge knock-throughs in Richmond?
Structural work in Richmond needs a building notice or full plans application to the local council's building control team or a registered building control approver. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
Will the ceiling crack when the wall is removed?
Some minor cracking in old lath and plaster ceilings is possible, even with careful propping, because the structure is being disturbed. We prop to spread the load and protect ceilings where we can, and any cracks are filled or repaired as part of making good. Sound plaster normally stays intact.
Is the wall between two reception rooms load-bearing?
In most period terraces and semis it is, because it carries the floor joists and the wall between the bedrooms above. Some later houses have lighter partitions in this position, so the only way to be sure is an engineer's inspection. We arrange this during the survey and design stage.
How wide can a through-lounge opening be?
That depends on what the wall carries and how the beam ends can be supported, and the structural engineer sets it. Many owners go nearly full width, keeping short nibs at each end, while others choose a narrower opening to keep two distinct rooms. Wider spans need heavier steel and sometimes columns.
Do I need a party wall agreement for through-lounge knock-throughs in Richmond?
Yes, if the beam bears into a shared wall: the Party Wall etc. Act 1996 applies in England and Wales, and a party structure notice must be served at least two months before that work starts. We arrange it through a party wall surveyor.