Steel BeamInstallers
Finished open-plan kitchen diner with a plastered boxed beam across the ceiling

Kitchen-diner knock-throughs · Vale of Glamorgan

Kitchen-diner knock-throughs in the Vale of Glamorgan

Survey, engineer's design and installation of kitchen-diner knock-throughs anywhere in the Vale of Glamorgan.

  • Itemised written quote
  • Beam sized by a structural engineer
  • Covering the Vale of Glamorgan and nearby

Free survey in the Vale of Glamorgan

Tell us about your kitchen-diner knock-throughs project in the Vale of Glamorgan.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Planning kitchen-diner knock-throughs in the Vale of Glamorgan

Kitchen-diner knock-throughs remove the wall between a kitchen and a dining room to create one open-plan room, with a steel beam carrying whatever the wall supported. The work is planned around the kitchen itself: gas, water, waste and extraction runs, where units and any island will go, and how the ceiling should look once the steel is in.

We carry out kitchen-diner knock-throughs throughout the Vale of Glamorgan, for homeowners, landlords and builders who need the structural part done properly. That includes Barry and Penarth, plus smaller towns and villages nearby. You get an itemised written quote that shows the calculations, approvals, steel, labour and finishing as separate lines.

Key points for your project

  • The structural work comes first, then first-fix electrics and plumbing, plastering, flooring and finally the kitchen fit. Booking the kitchen fitter only once the beam has passed inspection and the plaster has dried avoids units going onto damp walls.
  • While the wall is out you will usually be without a working kitchen for several days. Many households set up a kettle, microwave and fridge in another room for that period and plan simple meals that need little cooking.
  • Sinks and dishwashers usually sit on an outside wall, but supply pipes and waste runs sometimes cross the internal wall. Moving the sink to an island means planning a waste route with enough fall under the floor, which affects how the floor is prepared.
  • Where the wall stood there is usually a strip of footing or a change in floor level between the two rooms. It is levelled with screed or timber so one continuous floor finish, such as tiles or engineered boards, can run straight across.
  • Older kitchens can hide asbestos in textured ceiling coatings, floor tiles, boxing around pipes or the backing of old heaters. In buildings from before 2000 it must be identified before the fabric is disturbed, so a survey of the affected area is arranged first.

From survey to sign-off in the Vale of Glamorgan

  1. Survey in the Vale of Glamorgan

    We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.

  2. Engineer's design

    A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.

  3. Building control

    We submit the application or notice to Vale of Glamorgan Council under the Building Regulations as they apply in Wales, before work starts.

  4. Install and sign-off

    Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.

What do kitchen-diner knock-throughs cost in the Vale of Glamorgan?

As a guide, budget £2,300–£5,450 including VAT for kitchen-diner knock-through in the Vale of Glamorgan, based on published UK cost guides adjusted for prices in Wales (-9%).

JobTypical guide rangeWhat it usually covers
Kitchen-diner knock-through£2,300–£5,450Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra)
Load-bearing wall removal with steel beam£1,800–£4,550Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good
Plastering and making good£270–£1,090Boxing the beam, bead and skim, reveals, floor infill where the wall stood and tidy-up
Fire protection to a steel beam£140–£550 per beamFire-rated board boxing or an intumescent coating system as specified

Figures include our approximate regional adjustment for prices in Wales (-9%) and are rounded. How these figures are worked out.

Approvals in the Vale of Glamorgan

In Wales, structural alterations come under the Building Regulations 2010 as they apply in Wales. Vale of Glamorgan Council handles building control for the Vale of Glamorgan. For work started or approved from 1 July 2026, the Welsh system uses an application to building control, dutyholders appointed in writing, a commencement notice before work starts and a compliance statement at the end.

The Party Wall etc. Act 1996 applies in Wales as well as England, so a beam bearing into a shared wall needs a party structure notice at least two months before work starts. We arrange notices through a party wall surveyor.

Building rules in Wales

Kitchen-diner knock-throughs by town

Questions about kitchen-diner knock-throughs in the Vale of Glamorgan

How soon can kitchen-diner knock-throughs start in the Vale of Glamorgan?

Start dates depend on the engineer's calculations, the building control approval and, where needed, party wall notice periods. We give you a realistic timetable after the survey and keep you updated as each approval comes through.

Do you cover the Vale of Glamorgan for kitchen-diner knock-throughs?

Yes. We carry out kitchen-diner knock-throughs in the Vale of Glamorgan. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

Can I have a kitchen island where the wall used to be?

Often you can, but it depends on whether the engineer needs a column and where the beam ends bear. If an island is part of the plan, tell us at the survey so the steel can be designed around it. Plumbing or power to an island also needs a route under the floor.

Can the steel beam be hidden in the ceiling?

Yes, a flush beam can be set into the ceiling void so there is no step between the kitchen and dining ceilings. It needs enough joist depth and more labour to connect the joists to the steel, so it costs more than a downstand. The engineer confirms whether it is possible in your house.

Do I need permission from my landlord or freeholder to open up a kitchen?

If you own a leasehold flat, usually yes. The lease will normally require the freeholder's or landlord's written consent for structural alterations, so get that before any work is booked. Freehold houses do not need this, and planning permission is not normally needed for internal changes unless the building is listed.

Can I knock my kitchen and dining room into one?

In most houses, yes. The wall can be removed even if it is load-bearing, as long as a steel beam designed by a structural engineer takes over the load and building control approves the work. The main things to check early are what the wall carries, where services run, and whether the layout still works around any column.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.