Basement & cellar steels · Eltham
Basement & cellar steels in Eltham
Basement & cellar steels in Eltham, from free survey to completion certificate.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our basement & cellar steels service in Eltham
If you live in Eltham, basement & cellar steels can usually be planned and priced after a single survey visit. Our coverage runs across London, so nearby villages are included too. We cover DA15, DA16, SE3, SE7 and SE9, and we fix the price in writing once the layout and scope are agreed.
Turning a cellar into a habitable room, or digging a new basement, nearly always means moving or removing walls that hold up the rest of the house. Steel beams and columns take over that support, often while the existing walls are being deepened by underpinning and the space is protected against water.
Things to plan for
- Getting steel into a basement means lowering it through a lightwell, a stair opening or a temporary hole in the ground floor. Long beams may be designed in bolted sections so they can be handled in tight below-ground spaces.
- Cellars often house gas meters, the incoming water main, the electricity supply and old drainage. These are mapped before work starts, gas work must by law be done by a Gas Safe registered engineer, and the electricity network operator may need to move a supply.
- Basement steel frames often rely on columns because there is nowhere else to land the load. Each column sits on its own foundation or a thickened part of the slab, and its position needs agreeing early so it does not end up in the middle of a room.
- Below-ground rooms need a waterproofing design, often a cavity drain membrane, a tanking system or both. Column bases and beam bearings that pass through the waterproofing are detailed so they do not become a route for water.
- Headroom is precious below ground, and a deep downstand beam can make a room feel cramped. The engineer may use a shallower but heavier section or set the steel into the ground floor zone, and that choice is made at design stage.
From survey to sign-off in Eltham
Free visit
A short visit to Eltham to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
What do basement & cellar steels cost in Eltham?
As a guide, budget £3,200–£8,300 including VAT for basement or cellar steelwork in Eltham, based on published UK cost guides adjusted for London prices (+28%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Basement or cellar steelwork | £3,200–£8,300 | Beams and columns with pad foundations under the floor above (excavation and waterproofing extra) |
| Steel column or post | £640–£1,920 per column | Column supplied and fitted with base and cap plates on a pad foundation |
| Building control fees | £320–£830 | Building notice or full plans fee and inspections; varies by council or approver |
| Temporary works and propping | £190–£640 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
Figures include our approximate regional adjustment for London prices (+28%) and are rounded. How these figures are worked out.
Approvals in Eltham
In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either the local council's building control team or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Questions about basement & cellar steels in Eltham
How soon can basement & cellar steels start in Eltham?
Start dates depend on the engineer's calculations, the building control approval and, where needed, party wall notice periods. We give you a realistic timetable after the survey and keep you updated as each approval comes through.
Do you also work near Eltham?
Yes. We also cover nearby towns including Blackheath, Welling, Catford and Greenwich.
How is steel protected from damp in a basement?
Steel below ground is protected against corrosion as the engineer specifies, which may mean a heavier-duty paint system or galvanising. It is also kept on the dry side of the waterproofing where possible, and fixings through the waterproofing are detailed so they do not let water in.
How much headroom do I need for a basement conversion?
Enough for the finished room to be comfortable and for the stair to meet the building regulations headroom rules. Steel depth affects that, so the engineer may choose a shallower section or set beams within the floor above. Where headroom is too tight, lowering the floor with underpinning may be an option.
What paperwork will I get for basement steelwork?
You should end up with the engineer's calculations and drawings, the building control completion certificate, the waterproofing details and, where it applied, the party wall paperwork. Keep them together, as surveyors and solicitors usually ask for them when the property is sold or remortgaged.
Who approves basement & cellar steels in Eltham?
Structural work in Eltham needs a building notice or full plans application to the local council's building control team or a registered building control approver. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.