Wider doorways & openings · Pembroke Dock
Wider doorways & openings in Pembroke Dock
Steelwork, approvals and making good for wider doorways & openings in Pembroke Dock and nearby.
- Free survey visit in Pembroke Dock
- Engineer's calculations arranged
- Building control handled for you
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
What wider doorways & openings involve in Pembroke Dock
Our wider doorways & openings service in Pembroke Dock covers everything from the first visit to the completion paperwork. We also cover the surrounding towns and villages in Pembrokeshire. Postcode districts we cover here include SA71, SA72 and SA73.
We arrange a survey visit, structural calculations where the wall is load-bearing, building control, propping, the lintel or beam, new door linings if you want them, and making good. One itemised written quote covers the lot, and the price is fixed in writing once the opening size and finish are agreed.
What to expect
- Hallway walls are often load-bearing because they line up with walls upstairs and carry the floor joists or the stairs. A wall that sounds hollow when knocked is usually a stud partition, but older homes can have timber walls that still carry loads, so the engineer checks.
- For a modest increase in width, a lintel may be all that is needed, while a wider opening carrying a floor or wall usually needs steel. The engineer chooses the type and size from the actual loads, never from the opening width alone.
- In older houses, a doorway may already have a timber lintel that has rotted or a brick arch that is hard to extend. These are replaced rather than added to, and the engineer allows for soft lime mortar and any cracking found once the wall is opened.
- Each side of the new opening needs enough solid wall for the lintel or beam to sit on. If the opening runs close to a corner, another doorway or a chimney breast, there may not be enough masonry, and a column or padstone may be required.
- Openings are cut with a masonry saw where possible rather than broken out with a hammer. Clean cuts keep the brickwork either side sound, give a straighter edge for plastering and send less vibration through the rest of the wall.
Four stages, one team
Look and measure
We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.
Design and price
Calculations come back from the engineer and we confirm your fixed written price, line by line.
Building control
We submit the application or notice to Pembrokeshire County Council under the Building Regulations as they apply in Wales, before work starts.
Fit, inspect, finish
The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.
Guide prices for wider doorways & openings in Pembroke Dock
As a guide, budget £910–£2,280 including VAT for widening an internal doorway in Pembroke Dock, based on published UK cost guides adjusted for prices in Wales (-9%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Widening an internal doorway | £910–£2,280 | Opening widened with a new lintel or short beam, approval where structural, and making good |
| Lintel replacement | £360–£1,090 per lintel | Propping, removing the old lintel, new lintel set on beds and brickwork made good |
| RSJ supply and fit (single beam) | £730–£2,280 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
| Structural calculations for a beam | £230–£680 | Site measure or photos, beam and padstone design and calculations for building control |
Figures include our approximate regional adjustment for prices in Wales (-9%) and are rounded. How these figures are worked out.
Building rules for Pembroke Dock
Welsh building regulations treat beams and new openings as controlled building work. We apply to Pembrokeshire County Council on your behalf before anything is removed, give the commencement notice the 2026 Welsh rules require, and the steel is checked before it is boxed in.
The Party Wall etc. Act 1996 applies in Wales as well as England, so a beam bearing into a shared wall needs a party structure notice at least two months before work starts. We arrange notices through a party wall surveyor.
Wider doorways & openings near Pembroke Dock
- Pembroke 1.8 mi
- Milford Haven 4.4 mi
- Haverfordwest 7.5 mi
- Tenby 10.5 mi
Questions about wider doorways & openings in Pembroke Dock
Can you work on older or listed homes in Pembroke Dock?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
What happens at the survey visit in Pembroke Dock?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Will widening a doorway make a mess?
There is some dust and noise, mainly on the day the opening is cut. We screen the area, protect floors along the route and use dust extraction on saws where possible. Rooms either side are affected for a day or two, while the rest of the house stays in normal use.
What is included in the price for a wider doorway?
The itemised written quote lists the survey, any engineer's calculations and building control fees, propping, cutting the opening, the lintel or steel, linings or plastered reveals, and making good. Moving services, supplying doors and flooring joins appear as separate lines. The price is fixed in writing once the size and finish are agreed.
How long does it take to widen a doorway?
The structural part usually takes one to two working days: propping, cutting the opening, fitting the lintel or beam and packing it. Plastering follows, then a few days of drying before linings are painted or a new door is hung. Building control inspection fits in once the support is in place.