Through-lounge knock-throughs · Eltham
Through-lounge knock-throughs in Eltham
Through-lounge knock-throughs in Eltham, from free survey to completion certificate.
- Itemised written quote
- Beam sized by a structural engineer
- Covering Eltham and nearby
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
What through-lounge knock-throughs involve in Eltham
For homes in Eltham and the DA15, DA16, SE3, SE7 and SE9 districts, we handle through-lounge knock-throughs from survey to sign-off. The wider London area is covered as well. The beam is sized by a structural engineer and inspected before it is boxed in.
We plan the steel so the opening suits the room's proportions and keeps period features where you want them, from chimney breasts to cornicing. The survey visit, calculations from a qualified structural engineer, building control, party wall notices through a party wall surveyor where needed, propping, steel and making good are all set out in one itemised written quote.
Key points for your project
- With the wall gone, the floorboards on each side may run in different directions or sit at slightly different heights. Matching reclaimed boards can be fitted across the old wall line, or the floor can be levelled for a new continuous finish.
- Chimney breasts on the party wall in each room often sit close to the dividing wall. The beam may need to bear near them or avoid them, so the engineer checks how the breasts and flues relate to the new bearing before the opening width is fixed.
- The steel commonly needs fire protection to meet building regulations, usually by boxing it in fire-rated plasterboard and skimming it. In period rooms the box can be finished with a matching cornice so it reads as part of the original ceiling.
- In most terraced houses the wall between the front and back rooms runs across the house and carries the floor above, plus the wall between the front and back bedrooms. It is normally load-bearing, but the engineer still checks before any design is drawn up.
- Many owners leave short nibs of wall at each end of the opening rather than going fully wall to wall. Nibs can give the beam a bearing, line up with the chimney breasts and keep the feel of two linked rooms, but the engineer decides whether they are adequate.
Four stages, one team
Survey in Eltham
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
What do through-lounge knock-throughs cost in Eltham?
As a guide, budget £3,200–£7,050 including VAT for through-lounge knock-through in Eltham, based on published UK cost guides adjusted for London prices (+28%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Through-lounge knock-through | £3,200–£7,050 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Chimney breast removal (ground floor) | £1,900–£3,850 | Ground-floor breast removed, steel to support the breast above, building control and making good |
| Load-bearing wall removal with steel beam | £2,550–£6,400 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
| Kitchen-diner knock-through | £3,200–£7,700 | Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra) |
Figures include our approximate regional adjustment for London prices (+28%) and are rounded. How these figures are worked out.
Building control and neighbours in Eltham
Structural openings in English homes need building regulations approval before work starts. The local council's building control team can deal with it, or you can use a registered building control approver. Either way the steel is inspected before it is covered, and a completion certificate is issued at the end. Keep it safe for when you sell.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Local questions answered
Do you cover Eltham for through-lounge knock-throughs?
Yes. We carry out through-lounge knock-throughs in Eltham and the DA15, DA16, SE3, SE7 and SE9 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.
Do you also work near Eltham?
Yes. We also cover nearby towns including Blackheath, Welling, Catford and Greenwich.
Will the ceiling crack when the wall is removed?
Some minor cracking in old lath and plaster ceilings is possible, even with careful propping, because the structure is being disturbed. We prop to spread the load and protect ceilings where we can, and any cracks are filled or repaired as part of making good. Sound plaster normally stays intact.
Do I need a party wall agreement for a through-lounge?
In England and Wales, yes, if the beam end will be cut into the wall shared with your neighbour: a party structure notice must be served at least two months before that work. Your neighbour can consent or dissent. Scotland and Northern Ireland have no Party Wall Act, so title deeds and the general law apply instead.
Should I keep the chimney breasts when knocking through?
Most people do, because the breasts frame the opening and support the stack above. Removing a chimney breast is a separate structural job needing its own design and approval, and it affects your neighbour if the stack is shared. Keeping them usually simplifies the steelwork and preserves the character of the room.
Can you work on older or listed homes in Eltham?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.