Steel BeamInstallers
Steel column with a bolted base plate on a concrete pad supporting a beam

Steel columns & posts · Highlands

Steel columns & posts in the Highlands

Survey, engineer's design and installation of steel columns & posts anywhere in the Highlands.

  • Itemised written quote
  • Beam sized by a structural engineer
  • Covering the Highlands and nearby

Free survey in the Highlands

Tell us about your steel columns & posts project in the Highlands.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Planning steel columns & posts in the Highlands

A steel column is an upright structural element that collects the load from a beam, floor or roof and carries it down to a foundation. In homes it is usually a square or circular hollow section or a universal column, welded to a base plate fixed to a concrete pad, and sized by a structural engineer for the load it carries.

We carry out steel columns & posts throughout the Highlands, for homeowners, landlords and builders who need the structural part done properly. We can survey in places such as Dingwall, Aviemore and Thurso and the villages around them. You get an itemised written quote that shows the calculations, approvals, steel, labour and finishing as separate lines.

Key points for your project

  • The noisiest part is cutting the floor and digging the pad, usually a day's work. The concrete then needs time to gain strength, so the column is often fitted on a later visit once it has cured enough to take load.
  • The base plate is welded to the foot of the column and fixed to the pad with holding-down bolts. A cap plate at the top bolts to the beam above, so the two act together and the beam cannot slide off its support.
  • Steel at floor level can corrode if it sits in damp. The detail at the base is designed to keep damp away, using grout, protective paint and the floor's damp-proof membrane, and a column in a cellar or garage may need a heavier coating.
  • While the existing support is removed or the new column goes in, props hold the beam and the structure above. They are only taken out once the column is fixed, packed tight at the head and grouted at the base.
  • A post is needed when a beam has nothing adequate to bear on, or when a span is long enough that a central support gives a shallower, lighter beam. The engineer weighs up a column against a deeper beam for each layout.

From survey to sign-off in the Highlands

  1. Free visit

    A short visit to the Highlands to see the job, agree what you want and check the bearings, floors and services that affect the design.

  2. Calculations

    The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.

  3. Building warrant

    A building warrant is applied for from The Highland Council, and work starts only once the warrant has been granted.

  4. Steel in, made good

    On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.

How much should I budget in the Highlands?

As a guide, budget £460–£1,360 per column including VAT for steel column or post in the Highlands, based on published UK cost guides adjusted for prices in Scotland (-9%).

JobTypical guide rangeWhat it usually covers
Steel column or post£460–£1,360 per columnColumn supplied and fitted with base and cap plates on a pad foundation
Fire protection to a steel beam£140–£550 per beamFire-rated board boxing or an intumescent coating system as specified
RSJ supply and fit (single beam)£730–£2,280 per beamBeam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately)
Kitchen-diner knock-through£2,300–£5,450Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra)

Figures include our approximate regional adjustment for prices in Scotland (-9%) and are rounded. How these figures are worked out.

Approvals in the Highlands

In Scotland, structural alterations need a building warrant under the Building (Scotland) Act 2003, and work must not start until the warrant is granted. For the Highlands, warrants are handled by The Highland Council's building standards service. When the work is finished, a completion certificate is submitted and has to be accepted by the council.

Scotland has no Party Wall Act. Work affecting a shared wall is governed by your title deeds and the general law, and in flats by the Tenements (Scotland) Act 2004, so it is sensible to agree the work with neighbours in writing before starting.

Building rules in Scotland

Steel columns & posts in the Highlands: your questions

Do I need a party wall agreement for steel columns & posts in the Highlands?

There is no Party Wall Act in Scotland. Your title deeds and the general law apply instead, and the Tenements (Scotland) Act 2004 for flats, so agree the work with your neighbour in writing before it starts.

Who approves steel columns & posts in the Highlands?

Structural work in the Highlands needs a building warrant from The Highland Council, granted before work starts. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.

Does a steel column need a foundation?

Almost always, yes. A column puts a concentrated load onto a small patch of ground, and most floor slabs are not designed for that. The engineer specifies a concrete pad of a set size and depth, building standards usually inspects the hole before concrete is poured, and the column is bolted down once the pad has cured.

How long does it take to fit a steel post?

The column itself can often be fixed in a day, but the whole job usually spans a few working days. The floor is cut and the pad dug, building standards inspects it, the concrete is poured and left to cure, and then the column goes in and is packed tight to the beam.

Can you replace an old timber or cast iron post?

Usually, yes. Old posts in cellars, garages and converted shops are often undersized, rotten or of unknown strength. The engineer assesses the load they carry and specifies a new steel column and pad. The structure is propped while the old post comes out, and the new column is packed tight before the props are removed.

Can a steel post replace a supporting wall?

Yes, in many layouts a wall can come out with a beam above it and one or more posts taking the beam's load down to the ground. This keeps most of the openness while shortening the span. The engineer decides how many posts are needed and where they can go.

Which towns in the Highlands do you cover?

We cover towns including Inverness, Fort William, Nairn and Thurso, plus the villages and smaller towns around them.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.