
Steel beam replacement & repair · Selkirk
Steel beam replacement & repair in Selkirk
Steelwork, approvals and making good for steel beam replacement & repair in Selkirk and nearby.
- Price fixed in writing once scope is agreed
- Building warrant arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning steel beam replacement & repair in Selkirk
We cover steel beam replacement & repair in Selkirk (TD7) and the streets around it. The wider the Scottish Borders area is covered as well. Each job is designed by a structural engineer and approved through Scottish Borders Council before work begins.
We start with a survey visit, arrange an engineer's inspection, then carry out whatever repair the engineer specifies, from new bearings to strengthening or full replacement. We handle building standards and the temporary propping, and you get an itemised written quote before anything starts.
What to expect
- Corrosion usually starts where water reaches the steel: under a leaking flat roof, behind a shopfront fascia, in a damp external wall or at a cellar ceiling. Light surface rust can often be cleaned and treated, while heavy loss of section changes the beam's strength.
- Shop beams over old shopfronts are a common repair job. They often carry the whole front wall of the upper floors, sit behind fascias where rain gets in, and may have been cut or altered when shopfronts were replaced in the past.
- A repair only lasts if the cause is dealt with too. A leaking roof, blocked gutter or bridged damp-proof course that rusted the beam needs fixing first, otherwise new protective coatings will break down in the same way.
- Whether to strengthen or replace is the engineer's decision. Plating, where steel plates are fixed to the flanges, can add capacity without removing the beam, but it is not suitable for every section, connection or level of damage.
- Beams fitted without calculations, whether decades ago or more recently without approval, may be smaller than the loads require, particularly in shop conversions and older knock-throughs. An engineer can check the existing section against the actual loads and say whether it is adequate.
What happens, step by step
Survey in Selkirk
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building warrant
A building warrant is applied for from Scottish Borders Council, and work starts only once the warrant has been granted.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building standards inspects it, and we make good.
What does steel beam replacement & repair cost in Selkirk?
As a guide, budget £1,800–£5,000 including VAT for steel beam replacement in Selkirk, based on published UK cost guides adjusted for prices in Scotland (-9%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Steel beam replacement | £1,800–£5,000 | Propping, removing the failed beam, new steel on proper bearings, approval and making good |
| RSJ supply and fit (single beam) | £730–£2,280 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
| Building warrant fee | £215–£435 | Statutory fee set by the estimated value of the work: £215 up to £5,000, rising on a sliding scale (fees from 1 April 2026) |
| Shop or commercial structural opening | £4,550–£13,650 | Transfer beam and columns for opening units together or forming a shopfront opening |
Figures include our approximate regional adjustment for prices in Scotland (-9%) and are rounded. How these figures are worked out.
Building rules for Selkirk
Steel beam work in Selkirk needs a building warrant from Scottish Borders Council. The structural design is part of the application, and the council's building standards team accepts the completion certificate once the work is done as approved.
There is no party wall notice system in Scotland. Instead, check your title deeds and, for flats, the tenement management scheme, and talk to neighbours early if the beam bears into a shared wall.
Local questions answered
Do you cover Selkirk for steel beam replacement & repair?
Yes. We carry out steel beam replacement & repair in Selkirk and the TD7 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.
Who approves steel beam replacement & repair in Selkirk?
Structural work in Selkirk needs a building warrant from Scottish Borders Council, granted before work starts. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
Can a rusty steel beam be repaired?
Often, yes. Surface rust can usually be cleaned back to sound steel and treated with a protective coating. Where corrosion has eaten into the flanges or web, the engineer works out the remaining strength and decides whether plating will restore it or the beam needs replacing. The source of the moisture must be fixed as well.
Is it cheaper to repair or replace a steel beam?
Repair is often less disruptive and can cost less, but only when the engineer confirms it will do the job. Heavily corroded or badly undersized beams may need replacing anyway, and plating in awkward positions is not always cheaper. We price the option the engineer specifies in an itemised written quote.
What does it mean to plate a steel beam?
Plating means fixing extra steel plates to the beam, usually along the flanges, to increase its strength or stiffness without taking it out. The plates are bolted or welded according to the engineer's design. It suits some beams well, but not all, and the engineer checks the connections and bearings before specifying it.
Do I need a party wall agreement for steel beam replacement & repair in Selkirk?
There is no Party Wall Act in Scotland. Your title deeds and the general law apply instead, and the Tenements (Scotland) Act 2004 for flats, so agree the work with your neighbour in writing before it starts.