Side return extension steels · Hertfordshire
Side return extension steels in Hertfordshire
Survey, engineer's design and installation of side return extension steels anywhere in Hertfordshire.
- Free survey visit in Hertfordshire
- Engineer's calculations arranged
- Building control handled for you
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our side return extension steels service in Hertfordshire
Side return extension steels are the beams and columns that replace the side wall of a terraced house's rear wing when the narrow passage beside it is built over. Sized by a structural engineer, they carry the wall, floor and roof loads above along the line of the old wall, so the kitchen and the infilled side return become one wide room.
Homes across Hertfordshire range from Victorian terraces to post-war semis and newer estates, and side return extension steels look different in each. Coverage takes in Cheshunt, Bishops Stortford and Stevenage and everywhere in between. We plan the steel, the temporary support and the approvals around the building, then fix the price in writing once the scope is agreed.
What to expect
- Side passages often carry the house drains and rainwater pipes from the outrigger roof. Manholes and pipe runs are located early, and a shared or public sewer under the passage may need the water company's agreement before building over or near it.
- Where the beam along the old side wall meets a beam across the main house, the junction carries a heavy point load. The engineer usually details a column or a bolted connection there, which needs a solid foundation beneath it.
- Some owners leave the long beam on show as a feature under a glazed roof. Exposed steel still needs fire protection where building control requires it, which usually means a specified intumescent paint system applied to the correct thickness.
- The kitchen is usually out of use while the side wall comes down and the frame goes in, so many households set up a temporary kitchen elsewhere in the house. The rest of the property normally stays in use throughout the steel stage.
- Many outrigger kitchens have a chimney breast on the side wall being removed or on the party wall. Its position affects where beams can bear, and if any part of the breast is taken out, what remains above has to be supported as the engineer specifies.
How the job runs in Hertfordshire
Survey in Hertfordshire
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for side return extension steels in Hertfordshire
As a guide, budget £3,700–£9,000 including VAT for side return extension steelwork in Hertfordshire, based on published UK cost guides adjusted for prices in the East of England (+6%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Side return extension steelwork | £3,700–£9,000 | Beams and posts along the old side wall line, propping and approvals (extension build extra) |
| Temporary works and propping | £160–£530 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Steel column or post | £530–£1,590 per column | Column supplied and fitted with base and cap plates on a pad foundation |
| Structural calculations for a beam | £260–£800 | Site measure or photos, beam and padstone design and calculations for building control |
Figures include our approximate regional adjustment for prices in the East of England (+6%) and are rounded. How these figures are worked out.
Approvals in Hertfordshire
For Hertfordshire, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Local questions answered
Can you work on older or listed homes in Hertfordshire?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
Can I stay at home while the work is done in Hertfordshire?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.
Does a glazed roof affect the steel beam?
Yes. Glazed roofs need the beam they sit on to stay very straight under load, so the engineer may set a stricter deflection limit than for a solid roof. That can mean a deeper or heavier steel section, and the roof supplier's details need sharing early.
Can the steel beam be left exposed in a side return?
Yes, and many people like the look of exposed steel under a glazed roof. It usually still needs fire protection, so it is coated with an intumescent paint system to the specified thickness, then finished in your chosen colour. The engineer and building control confirm what protection is required.
Do I need a party wall agreement for a side return extension?
In England and Wales it is very likely. Building on or near the boundary, excavating close to the neighbour's foundations or cutting into a shared wall can all be notifiable under the Party Wall etc. Act 1996. Notices are arranged through a party wall surveyor on your behalf, and we do not give legal advice.
What steels do I need for a side return extension?
Usually a long beam along the line of the old outrigger side wall, often a second beam opening the back of the main house, and one or more columns where the loads meet. The exact arrangement depends on the house and the layout, and a structural engineer specifies every beam, column and connection.