Side return extension steels · Antrim and Newtownabbey
Side return extension steels in Antrim and Newtownabbey
Calculations, approvals, propping, steel and making good for side return extension steels across Antrim and Newtownabbey.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning side return extension steels in Antrim and Newtownabbey
Side return extension steels are the beams and columns that replace the side wall of a terraced house's rear wing when the narrow passage beside it is built over. Sized by a structural engineer, they carry the wall, floor and roof loads above along the line of the old wall, so the kitchen and the infilled side return become one wide room.
If you are planning side return extension steels in Antrim and Newtownabbey, the order of work matters as much as the steel: survey, calculations, approval, propping, installation, inspection and making good. We can survey in places such as Newtownabbey and Antrim and the villages around them. We run that sequence for you as one job with one point of contact.
Worth knowing before you start
- Propping a side return is awkward because space in a narrow kitchen is tight and the infill side is often open ground. Props outside may stand on temporary pads or boards, set so they do not sink or shift in wet weather.
- Side passages often carry the house drains and rainwater pipes from the outrigger roof. Manholes and pipe runs are located early, and a shared or public sewer under the passage may need the water company's agreement before building over or near it.
- Some owners leave the long beam on show as a feature under a glazed roof. Exposed steel still needs fire protection where building control requires it, which usually means a specified intumescent paint system applied to the correct thickness.
- Planning rules for side return infills depend on the house and its location, and some need a full planning application rather than relying on permitted development. The steel design forms part of the building regulations approval either way.
- The side wall of a typical outrigger carries the first-floor wall above it, and sometimes the rear wing's roof and the joists of the room over the kitchen. That is why taking it out calls for a beam along its full length.
Four stages, one team
Look and measure
We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.
Design and price
Calculations come back from the engineer and we confirm your fixed written price, line by line.
Building control
A full plans application or building notice goes to Antrim and Newtownabbey Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Fit, inspect, finish
The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.
How much should I budget in Antrim and Newtownabbey?
As a guide, budget £3,000–£7,300 including VAT for side return extension steelwork in Antrim and Newtownabbey, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Side return extension steelwork | £3,000–£7,300 | Beams and posts along the old side wall line, propping and approvals (extension build extra) |
| Structural calculations for a beam | £220–£640 | Site measure or photos, beam and padstone design and calculations for building control |
| Temporary works and propping | £130–£430 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Steel column or post | £430–£1,290 per column | Column supplied and fitted with base and cap plates on a pad foundation |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building control and neighbours in Antrim and Newtownabbey
Removing a load-bearing wall in Northern Ireland needs building control approval from the council. Antrim and Newtownabbey Borough Council covers Antrim and Newtownabbey. The engineer's calculations support the application, and a completion certificate is issued after the final inspection.
The Party Wall etc. Act does not extend to Northern Ireland. Shared walls are dealt with under your title and the general law, so we recommend agreeing access and the work with your neighbour before it starts.
Side return extension steels by town
Side return extension steels in Antrim and Newtownabbey: your questions
Can I stay at home while the work is done in Antrim and Newtownabbey?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.
Which towns in Antrim and Newtownabbey do you cover?
We cover towns including Newtownabbey and Antrim, plus the villages and smaller towns around them.
Do I need planning permission for a side return extension?
It depends on the house and where it is. Some side return infills can be built under permitted development, but the rules for side extensions are restrictive, and conservation areas and listed buildings add further controls. Check with your local planning authority or architect before committing to a design.
How long does it take to fit side return steels?
Most side return steel frames take two to five working days on site, depending on the number of beams and columns and how easy access is. That covers propping, removing the old side wall, fitting the steels and packing them. Fire protection and finishes follow afterwards.
Does a glazed roof affect the steel beam?
Yes. Glazed roofs need the beam they sit on to stay very straight under load, so the engineer may set a stricter deflection limit than for a solid roof. That can mean a deeper or heavier steel section, and the roof supplier's details need sharing early.
What steels do I need for a side return extension?
Usually a long beam along the line of the old outrigger side wall, often a second beam opening the back of the main house, and one or more columns where the loads meet. The exact arrangement depends on the house and the layout, and a structural engineer specifies every beam, column and connection.