Steel BeamInstallers
Two retail units opened into one with a steel beam and columns

Shop & commercial openings · Woking

Shop & commercial openings in Woking

Shop & commercial openings for homes in GU21, GU22, GU23, designed by a structural engineer.

  • Price fixed in writing once scope is agreed
  • Building control arranged
  • Temporary works and making good included

Free survey in Woking

Tell us about the shop & commercial opening job in Woking.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Shop & commercial openings in Woking: how it works

Shop & commercial openings in Woking are planned around the house, not a standard kit. We also work in nearby Slough, roughly 13.3 miles away. We visit, measure and check what the wall carries, then arrange calculations and building control approval before any steel is ordered.

We carry out structural openings for small commercial premises across the UK, working to an engineer's design and handling building control. Work can be planned around opening hours, including out-of-hours shifts where the landlord and building allow, and coordinated with your shopfitter.

Things to plan for

  • Commercial premises often have three-phase power, alarm and data cabling, gas supplies and drainage running through the walls being altered. These are mapped at the survey, and any work on gas pipes must by law be done by a Gas Safe registered engineer.
  • Supporting a shopfront means temporary works right at the street edge. Permission from the highway authority may be needed for hoarding, scaffolding or a lifting vehicle on the pavement, and props are positioned so the public route stays safe.
  • Most commercial leases prohibit structural alterations without the landlord's written consent, often given as a licence for alterations. Securing it before work starts avoids disputes later, and we supply the drawings and calculations the landlord or their surveyor asks to see.
  • The main cost factors are the span and load above, whether columns or a goalpost frame are needed, the temporary works at the street, out-of-hours working, lifting equipment, and the fire protection and finish the opening requires.
  • Purely internal works may not need planning permission, but a new or altered shopfront changes the look of the building and may need it, particularly in a conservation area. Listed commercial buildings also need listed building consent for structural changes.

How the job runs in Woking

  1. Look and measure

    We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.

  2. Design and price

    Calculations come back from the engineer and we confirm your fixed written price, line by line.

  3. Building control

    We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.

  4. Fit, inspect, finish

    The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.

What do shop & commercial openings cost in Woking?

As a guide, budget £5,600–£16,800 including VAT for shop or commercial structural opening in Woking, based on published UK cost guides adjusted for prices in the South East (+12%).

JobTypical guide rangeWhat it usually covers
Shop or commercial structural opening£5,600–£16,800Transfer beam and columns for opening units together or forming a shopfront opening
Temporary works and propping£170–£560Props, spreaders, needles and sole plates for a typical opening, installed and struck
Steel goalpost frame£2,250–£6,700Two posts and a beam bolted as a frame, pad foundations, base plates and fitting
Steel beam replacement£2,250–£6,150Propping, removing the failed beam, new steel on proper bearings, approval and making good

Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.

Building rules for Woking

For Woking, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.

If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.

Building rules in England

Shop & commercial openings near Woking

Shop & commercial openings in Woking: your questions

Do you also work near Woking?

Yes. We also cover nearby towns including Guildford, Egham, Walton-on-Thames and Camberley.

Do you cover Woking for shop & commercial openings?

Yes. We carry out shop & commercial openings in Woking and the GU21, GU22, GU23 and GU24 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

Can I knock two shops into one?

Usually, yes, with the right approvals. The dividing wall is replaced with steel designed by a structural engineer, building control approves the work and the fire strategy is updated for the combined unit. You also need landlord consent if you lease either unit, and party wall notices in England and Wales if the steel bears into a wall shared with another owner.

Do I need an asbestos survey before work on my shop?

Usually, if the building dates from before 2000. The duty holder for commercial premises should already have an asbestos register, and before walls, ceilings or the shopfront are opened up, a refurbishment survey of the work area is needed wherever that register does not cover it, so any asbestos is dealt with first.

What kind of steel is used for a wide shop front?

The engineer chooses the section to suit the span and load. Wide frontages often use universal beams, sometimes paired or plated, and a goalpost frame of two columns and a beam where the existing piers cannot take the load. The steel is then fire protected and finished behind the fascia or boxing.

How soon can shop & commercial openings start in Woking?

Start dates depend on the engineer's calculations, the building control approval and, where needed, party wall notice periods. We give you a realistic timetable after the survey and keep you updated as each approval comes through.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.