Shop & commercial openings · Reigate
Shop & commercial openings in Reigate
Steelwork, approvals and making good for shop & commercial openings in Reigate and nearby.
- Itemised written quote
- Beam sized by a structural engineer
- Covering Reigate and nearby
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Shop & commercial openings in Reigate: how it works
Planning shop & commercial openings in Reigate? Our team covers RH1 and RH2 and the streets around them. It sits about 8.6 miles from Crawley, which we also cover. You get one written quote for the calculations, approvals, propping, steel and making good.
Commercial buildings often have a flat or offices above the shop, a heavy brick front and old steel or timber over the existing shopfront. Opening them up means supporting a lot of load at street level, usually with the public walking past, while keeping disruption to trading as low as possible.
Worth knowing before you start
- Joining two units can change the fire strategy. The wall between them may be a compartment wall, escape routes and travel distances alter, and the steel needs fire protection to the required period. The fire risk assessment should be updated to match the new layout.
- Many shopfronts sit under an old steel or timber beam hidden behind the fascia for decades. It may be corroded, undersized for what is above or bearing on decayed masonry, so it is opened up and checked before keeping it is even considered.
- Structural alterations to commercial premises need building regulations approval just as homes do, and in Scotland a building warrant before work starts. In England they usually go through a full plans application, because fire safety is assessed alongside the structure.
- The main cost factors are the span and load above, whether columns or a goalpost frame are needed, the temporary works at the street, out-of-hours working, lifting equipment, and the fire protection and finish the opening requires.
- A straightforward shopfront beam replacement can take a few days on site, while joining two units with several openings may run to a couple of weeks. The programme is agreed in writing before work starts so you can plan trading around it.
What happens, step by step
Survey in Reigate
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
What do shop & commercial openings cost in Reigate?
As a guide, budget £5,600–£16,800 including VAT for shop or commercial structural opening in Reigate, based on published UK cost guides adjusted for prices in the South East (+12%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Shop or commercial structural opening | £5,600–£16,800 | Transfer beam and columns for opening units together or forming a shopfront opening |
| Steel goalpost frame | £2,250–£6,700 | Two posts and a beam bolted as a frame, pad foundations, base plates and fitting |
| Steel beam replacement | £2,250–£6,150 | Propping, removing the failed beam, new steel on proper bearings, approval and making good |
| Temporary works and propping | £170–£560 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.
Building control and neighbours in Reigate
For Reigate, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Shop & commercial openings in Reigate: your questions
Do I need a party wall agreement for shop & commercial openings in Reigate?
Yes, if the beam bears into a shared wall: the Party Wall etc. Act 1996 applies in England and Wales, and a party structure notice must be served at least two months before that work starts. We arrange it through a party wall surveyor.
Can you work on older or listed homes in Reigate?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
Can commercial steel beam work be done outside opening hours?
In many cases, yes. Noisy cutting and the main structural stages can be programmed for evenings, early mornings or weekends where the landlord, the building and neighbouring occupiers allow. Out-of-hours working is priced as a separate line on the itemised quote, so you can weigh it against closing for part of the job.
Does the beam above my shop window need replacing?
Not always, but it should be checked. Many shopfronts sit under an old steel, timber or concrete beam hidden behind the fascia, which may have corroded, rotted or been undersized for the wall above. An engineer inspects it once it is opened up and decides whether it can be kept, strengthened or must be replaced.
What kind of steel is used for a wide shop front?
The engineer chooses the section to suit the span and load. Wide frontages often use universal beams, sometimes paired or plated, and a goalpost frame of two columns and a beam where the existing piers cannot take the load. The steel is then fire protected and finished behind the fascia or boxing.
Do you cover Reigate for shop & commercial openings?
Yes. We carry out shop & commercial openings in Reigate and the RH1 and RH2 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.