Steel BeamInstallers
Brick wall partly removed with a primed steel beam on padstones and props beneath

Load-bearing wall removal · Ashford

Load-bearing wall removal in Ashford, Kent

Steelwork, approvals and making good for load-bearing wall removal in Ashford, Kent and nearby.

  • Itemised written quote
  • Beam sized by a structural engineer
  • Covering Ashford, Kent and nearby

Free survey in Ashford

Tell us about the load-bearing wall removal job in Ashford, Kent.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Planning load-bearing wall removal in Ashford, Kent

We carry out load-bearing wall removal in Ashford, Kent, covering the TN23, TN24 and TN25 postcode districts. The wider Kent area is covered as well. The job starts with a free survey visit so the engineer's calculations are based on your actual walls, floors and loads.

Most homes built before the 1970s have at least one internal wall that carries the floor joists, a wall upstairs or part of the roof. Taking it out is very doable, but the weight it carries has to go somewhere. A steel beam picks that load up and passes it down through padstones into walls or columns that can take it.

Key points for your project

  • If the wall carries a chimney breast, a wall upstairs and floor joists all at once, the engineer may specify a heavier beam or two beams side by side. The quote reflects that once calculations are back.
  • Expect some dust and noise for a day or two while the wall comes out. We screen the work area, protect floors and sweep up daily, and the rest of the house usually stays usable throughout.
  • Homes built before 2000 may contain asbestos in textured ceilings, boxing or old boards. Where there is a risk, a survey of the area being disturbed is arranged before the wall comes out.
  • The beam size depends on the span, what sits above and how the ends are supported. Two walls that look the same can need very different steel, which is why every beam is sized from calculations rather than guessed.
  • Building control is needed because removing a structural wall is controlled building work. Doing it without approval can cause problems when you come to sell, and putting it right afterwards costs far more than doing it properly first time.

Four stages, one team

  1. Look and measure

    We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.

  2. Design and price

    Calculations come back from the engineer and we confirm your fixed written price, line by line.

  3. Building control

    We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.

  4. Fit, inspect, finish

    The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.

What does load-bearing wall removal cost in Ashford, Kent?

As a guide, budget £2,250–£5,600 including VAT for load-bearing wall removal with steel beam in Ashford, Kent, based on published UK cost guides adjusted for prices in the South East (+12%).

JobTypical guide rangeWhat it usually covers
Load-bearing wall removal with steel beam£2,250–£5,600Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good
Kitchen-diner knock-through£2,800–£6,700Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra)
RSJ supply and fit (single beam)£900–£2,800 per beamBeam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately)
Through-lounge knock-through£2,800–£6,150Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill

Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.

Approvals in Ashford, Kent

In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either the local council's building control team or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.

Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.

Building rules in England

Load-bearing wall removal near Ashford

Local questions answered

Do you also work near Ashford, Kent?

Yes. We also cover nearby towns including Faversham, Canterbury, Folkestone and Sittingbourne.

Who approves load-bearing wall removal in Ashford, Kent?

Structural work in Ashford, Kent needs a building notice or full plans application to the local council's building control team or a registered building control approver. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.

What does the price include?

Our written quote is itemised, so you can see the calculations, building control fees, propping, steel, padstones, labour, fire protection and making good set out line by line. The price is fixed in writing once the layout and scope are agreed.

Will the beam show once the job is finished?

It depends on the design. Most beams sit just below the ceiling and are boxed in with plasterboard, leaving a small step. A beam can be set up into the floor void for a flat ceiling, which takes more work, or left exposed and painted where you want an industrial look.

Can I stay in the house while the wall is removed?

In most cases yes. The work area is screened, floors are protected and the house stays usable, though the rooms either side of the wall will be out of action for a few days and there will be some noise and dust.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.