Kitchen-diner knock-throughs · Surrey
Kitchen-diner knock-throughs in Surrey
Survey, engineer's design and installation of kitchen-diner knock-throughs anywhere in Surrey.
- Survey, design and installation in one
- Covering CR3, CR6, GU1, GU10
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our kitchen-diner knock-throughs service in Surrey
Kitchen-diner knock-throughs remove the wall between a kitchen and a dining room to create one open-plan room, with a steel beam carrying whatever the wall supported. The work is planned around the kitchen itself: gas, water, waste and extraction runs, where units and any island will go, and how the ceiling should look once the steel is in.
Kitchen-diner knock-throughs are one of the most common structural jobs in homes across Surrey. Coverage takes in Leatherhead, Esher and Ewell and everywhere in between. Every job starts with a survey visit, then calculations from a structural engineer, so the steel suits the house in front of us rather than a rule of thumb.
Key points for your project
- In many houses the kitchen and dining room wall carries the bedroom floor joists, and sometimes a bathroom wall above. Lifting a floorboard upstairs to see which way the joists run is a useful first look, though the engineer confirms what the wall actually supports.
- The structural work comes first, then first-fix electrics and plumbing, plastering, flooring and finally the kitchen fit. Booking the kitchen fitter only once the beam has passed inspection and the plaster has dried avoids units going onto damp walls.
- Sinks and dishwashers usually sit on an outside wall, but supply pipes and waste runs sometimes cross the internal wall. Moving the sink to an island means planning a waste route with enough fall under the floor, which affects how the floor is prepared.
- Older kitchens can hide asbestos in textured ceiling coatings, floor tiles, boxing around pipes or the backing of old heaters. In buildings from before 2000 it must be identified before the fabric is disturbed, so a survey of the affected area is arranged first.
- If the kitchen also opens onto the hallway, the change can affect the escape route from the bedrooms. Building control checks how people would get out in a fire, and smoke alarms, a fire door or other measures may be required as part of approval.
Four stages, one team
Survey in Surrey
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
How much should I budget in Surrey?
As a guide, budget £2,800–£6,700 including VAT for kitchen-diner knock-through in Surrey, based on published UK cost guides adjusted for prices in the South East (+12%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Kitchen-diner knock-through | £2,800–£6,700 | Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra) |
| Steel column or post | £560–£1,680 per column | Column supplied and fitted with base and cap plates on a pad foundation |
| Through-lounge knock-through | £2,800–£6,150 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Fire protection to a steel beam | £170–£670 per beam | Fire-rated board boxing or an intumescent coating system as specified |
Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.
Building rules for Surrey
Structural openings in English homes need building regulations approval before work starts. The local council's building control team can deal with it, or you can use a registered building control approver. Either way the steel is inspected before it is covered, and a completion certificate is issued at the end. Keep it safe for when you sell.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Kitchen-diner knock-throughs in Surrey: your questions
Can you work on older or listed homes in Surrey?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
What happens at the survey visit in Surrey?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Do I need building regulations for a kitchen-diner knock-through?
Yes, if the wall is structural. In England it needs building regulations approval through a full plans application or a building notice, in Wales an application under the Welsh regulations, and electrics and any change to fire escape routes are checked too. Scotland requires a building warrant before work starts, and Northern Ireland requires an application to council building control. We handle the application or notice.
Who moves the gas pipe for my cooker?
A Gas Safe registered engineer, because work on gas pipework must legally be done by one. If the pipe runs in or near the wall being removed, it is capped or rerouted before demolition starts and reconnected once the new layout is in place. We build this into the programme so it is not left to chance.
How long will I be without a kitchen?
The structural work itself usually takes three to six working days, and the kitchen is out of action during that time. After that come plastering, drying, flooring and the kitchen fit, so the overall period without a finished kitchen depends mostly on your fitter's programme and when the units are delivered.
Is the wall between my kitchen and dining room load-bearing?
It often is, particularly in older semis and terraces where it supports the bedroom floor joists. The clearest signs are joists bearing on it from above and a wall in the same position upstairs, but only an engineer's site check confirms it. We arrange that check as part of the survey and design stage.