Kitchen-diner knock-throughs · Wellington
Kitchen-diner knock-throughs in Wellington
Kitchen-diner knock-throughs in Wellington, from free survey to completion certificate.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our kitchen-diner knock-throughs service in Wellington
We carry out kitchen-diner knock-throughs in Wellington, covering the TF1, TF5 and TF6 postcode districts. We also work in nearby Telford, roughly 3.3 miles away. The job starts with a free survey visit so the engineer's calculations are based on your actual walls, floors and loads.
The wall between a kitchen and dining room is often a structural one, especially in semi-detached and terraced houses where it carries the floor joists for the bedrooms above. Opening it up gives the sociable, open-plan space most families want, but the kitchen brings extra things to plan: pipes, cables, an extractor, and a layout that has to work around the new steel.
What to expect
- Cooker hood ducting that currently runs out through the wall may need a new route once the wall goes. Ducting can often be run in the ceiling void alongside the beam, but the beam's position and depth need to be known first.
- A flush beam sits up within the depth of the ceiling so the kitchen and dining ceilings run as one flat surface. It suits continuous downlights and long runs of wall units, but each joist has to be connected into the beam, which adds labour.
- Settle the kitchen layout before the steel is designed. If the engineer needs a column or a deeper beam, it is far easier to plan an island, tall units or the hob position around it at drawing stage than after the units are ordered.
- Sinks and dishwashers usually sit on an outside wall, but supply pipes and waste runs sometimes cross the internal wall. Moving the sink to an island means planning a waste route with enough fall under the floor, which affects how the floor is prepared.
- Taking the wall out removes the switches and sockets on it, and an open-plan room usually needs a new lighting layout. Electrical work in England must comply with Part P of the building regulations where it is notifiable, so rewiring is planned early.
Four stages, one team
Free visit
A short visit to Wellington to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to Telford & Wrekin Council, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
What do kitchen-diner knock-throughs cost in Wellington?
As a guide, budget £2,500–£6,000 including VAT for kitchen-diner knock-through in Wellington, based on published UK cost guides adjusted for prices in the West Midlands (no adjustment).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Kitchen-diner knock-through | £2,500–£6,000 | Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra) |
| Through-lounge knock-through | £2,500–£5,500 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Plastering and making good | £300–£1,200 | Boxing the beam, bead and skim, reveals, floor infill where the wall stood and tidy-up |
| Load-bearing wall removal with steel beam | £2,000–£5,000 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
Figures include our approximate regional adjustment for prices in the West Midlands (no adjustment) and are rounded. How these figures are worked out.
Building control and neighbours in Wellington
For Wellington, building control is provided by Telford & Wrekin Council, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Kitchen-diner knock-throughs near Wellington
- Telford 3.3 mi
- Shrewsbury 9.9 mi
- Stafford 18.3 mi
- Wolverhampton 18.3 mi
- Loughton 18.5 mi
- Wednesfield 19.5 mi
Questions about kitchen-diner knock-throughs in Wellington
How soon can kitchen-diner knock-throughs start in Wellington?
Start dates depend on the engineer's calculations, the building control approval and, where needed, party wall notice periods. We give you a realistic timetable after the survey and keep you updated as each approval comes through.
Do I need a party wall agreement for kitchen-diner knock-throughs in Wellington?
Yes, if the beam bears into a shared wall: the Party Wall etc. Act 1996 applies in England and Wales, and a party structure notice must be served at least two months before that work starts. We arrange it through a party wall surveyor.
Do I need permission from my landlord or freeholder to open up a kitchen?
If you own a leasehold flat, usually yes. The lease will normally require the freeholder's or landlord's written consent for structural alterations, so get that before any work is booked. Freehold houses do not need this, and planning permission is not normally needed for internal changes unless the building is listed.
Should I do the knock-through before or after fitting a new kitchen?
Before. The steel, any column, the floor levelling and the plastering all need to be finished first, so the kitchen fitter works in a dry, square room with services already in position. Fitting units and then taking out a wall risks damage and rework, and the beam position can affect where wall units go.
Who moves the gas pipe for my cooker?
A Gas Safe registered engineer, because work on gas pipework must legally be done by one. If the pipe runs in or near the wall being removed, it is capped or rerouted before demolition starts and reconnected once the new layout is in place. We build this into the programme so it is not left to chance.