Steel BeamInstallers
Garage conversion with the old door opening being bricked up around a new window

Garage conversion openings · Solihull

Garage conversion openings in Solihull

Garage conversion openings for homes in B90, B91, B92, designed by a structural engineer.

  • Itemised written quote
  • Beam sized by a structural engineer
  • Covering Solihull and nearby

Free survey in Solihull

Tell us about the garage conversion opening job in Solihull.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

What garage conversion openings involve in Solihull

Solihull has a mix of housing, and garage conversion openings need a slightly different approach in each. We also work in nearby Birmingham, roughly 6.8 miles away. Whatever the age of the property, the steel goes in on proper bearings with temporary support in place throughout.

For integral garages with a bedroom above, the beam over the garage door matters even more, because it carries the front wall of the room upstairs. We arrange the survey visit, engineer's calculations, building control, propping, any steel and making good, with the structural items set out in one itemised written quote.

Worth knowing before you start

  • The beam or lintel over a garage door was designed to span an open gap. It may be timber, concrete or steel, and in older houses it can be undersized or corroded, so the engineer checks it before anything is built underneath or above it.
  • An integral garage is usually separated from the house by fire-resisting construction. If part of it stays as a garage or store, that separation must be kept, and any new door between garage and house normally needs to be a fire door.
  • Forming a doorway from the house into the converted garage often goes through a load-bearing wall, especially the original external wall of the house where the garage is attached. That opening needs a lintel or beam designed by the engineer.
  • Garages often hold gas meters, consumer units, boilers or water stopcocks. These are located at survey, and anything that needs moving is done by the right trade, including a Gas Safe registered engineer for any work on gas pipework.
  • A converted garage used as a bedroom needs a suitable means of escape, often an escape window, and every habitable room needs ventilation. These affect the size and type of window in the infill wall, so they are agreed before brickwork starts.

What happens, step by step

  1. Free visit

    A short visit to Solihull to see the job, agree what you want and check the bearings, floors and services that affect the design.

  2. Calculations

    The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.

  3. Building control

    We submit a building notice or full plans application to Solihull Council, so approval is in place before the wall is touched.

  4. Steel in, made good

    On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.

Guide prices for garage conversion openings in Solihull

As a guide, budget £1,000–£3,000 including VAT for garage door opening infill (structural part) in Solihull, based on published UK cost guides adjusted for prices in the West Midlands (no adjustment).

JobTypical guide rangeWhat it usually covers
Garage door opening infill (structural part)£1,000–£3,000Beam or lintel checked or replaced, foundation and infill wall for the old door opening (window and finishes extra)
Building control fees£250–£650Building notice or full plans fee and inspections; varies by council or approver
Lintel replacement£400–£1,200 per lintelPropping, removing the old lintel, new lintel set on beds and brickwork made good
Structural calculations for a beam£250–£750Site measure or photos, beam and padstone design and calculations for building control

Figures include our approximate regional adjustment for prices in the West Midlands (no adjustment) and are rounded. How these figures are worked out.

Approvals in Solihull

In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either Solihull Council or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.

If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.

Building rules in England

Garage conversion openings near Solihull

Questions about garage conversion openings in Solihull

Can you work on older or listed homes in Solihull?

Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.

Can I stay at home while the work is done in Solihull?

Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.

What happens to the beam over my garage door?

It is checked by the engineer. Many can stay, carrying the wall above as before, with the infill built underneath. If it is timber that has rotted, a corroded steel section or simply undersized for the loads, it is replaced, with the wall or room above propped while the new steel goes in.

What paperwork will I get when the conversion is done?

You should receive the engineer's calculations, a building control completion certificate for the conversion, and certificates for any electrical or gas work. Keep these together, as buyers' solicitors ask for evidence that a garage conversion was approved, especially where a garage has become a bedroom or living space.

Do I need planning permission to convert my garage?

Often not, because a garage conversion is largely internal work within permitted development. However, some newer estates have planning conditions that remove permitted development rights for garages, and listed buildings, flats and some front elevation changes need consent. Check your property's planning history with the council before committing.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.