Steel BeamInstallers
Garage conversion with the old door opening being bricked up around a new window

Garage conversion openings · Eastleigh

Garage conversion openings in Eastleigh

Steelwork, approvals and making good for garage conversion openings in Eastleigh and nearby.

  • Free survey visit in Eastleigh
  • Engineer's calculations arranged
  • Building control handled for you

Free survey in Eastleigh

Tell us about the garage conversion opening job in Eastleigh.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

About our garage conversion openings service in Eastleigh

Eastleigh has a mix of housing, and garage conversion openings need a slightly different approach in each. We also work in nearby Southampton, roughly 4.9 miles away. Whatever the age of the property, the steel goes in on proper bearings with temporary support in place throughout.

Converting a garage is a popular way to add a room without extending. Structurally, two things usually happen: the big garage door opening is filled in with a wall, window or door on proper foundations, and a doorway or wider opening is formed through the wall between the garage and the house.

Worth knowing before you start

  • The beam or lintel over a garage door was designed to span an open gap. It may be timber, concrete or steel, and in older houses it can be undersized or corroded, so the engineer checks it before anything is built underneath or above it.
  • Garage floors often sit lower than the house floor and may have no damp-proof membrane. The infill wall needs a damp-proof course linked to the existing walls, and the floor usually needs a membrane, insulation and screed raised to the house level.
  • Once the garage becomes a habitable room, the energy efficiency requirements of the building regulations apply. Walls, floor and roof normally need insulating to current standards, so the structural design and the thermal upgrade are planned together.
  • Most garage conversions do not need planning permission, but some estates have conditions removing permitted development rights for garages, and listed buildings or flats need consent. Changing the front elevation can also need permission in some areas.
  • Garages often hold gas meters, consumer units, boilers or water stopcocks. These are located at survey, and anything that needs moving is done by the right trade, including a Gas Safe registered engineer for any work on gas pipework.

What happens, step by step

  1. Free visit

    A short visit to Eastleigh to see the job, agree what you want and check the bearings, floors and services that affect the design.

  2. Calculations

    The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.

  3. Building control

    We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.

  4. Steel in, made good

    On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.

Guide prices for garage conversion openings in Eastleigh

As a guide, budget £1,100–£3,350 including VAT for garage door opening infill (structural part) in Eastleigh, based on published UK cost guides adjusted for prices in the South East (+12%).

JobTypical guide rangeWhat it usually covers
Garage door opening infill (structural part)£1,100–£3,350Beam or lintel checked or replaced, foundation and infill wall for the old door opening (window and finishes extra)
Structural calculations for a beam£280–£840Site measure or photos, beam and padstone design and calculations for building control
Steel beam replacement£2,250–£6,150Propping, removing the failed beam, new steel on proper bearings, approval and making good
RSJ supply and fit (single beam)£900–£2,800 per beamBeam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately)

Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.

Building control and neighbours in Eastleigh

Structural openings in English homes need building regulations approval before work starts. The local council's building control team can deal with it, or you can use a registered building control approver. Either way the steel is inspected before it is covered, and a completion certificate is issued at the end. Keep it safe for when you sell.

Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.

Building rules in England

Garage conversion openings near Eastleigh

Local questions answered

What happens at the survey visit in Eastleigh?

We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.

Do you cover Eastleigh for garage conversion openings?

Yes. We carry out garage conversion openings in Eastleigh and the SO50 and SO53 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

How long do the structural works for a garage conversion take?

Typically one to two weeks for the structural stage: digging and concreting the infill foundation, building the infill wall, and forming any new opening into the house. Building control inspections fit around these stages, and the insulation, electrics, plastering and flooring of the conversion follow on afterwards.

Can I convert an integral garage with a bedroom above?

Yes, and it is a common type of conversion. The main structural point is the beam over the garage door, which usually carries the front wall of the bedroom. The engineer checks its condition and capacity, and the floor between garage and bedroom may need fire protection and insulation upgrades as part of the work.

Can I knock through from my garage into the kitchen?

Usually, yes. The wall between an attached or integral garage and the house is often load-bearing, so the opening needs a lintel or steel beam designed by a structural engineer and approved by building control. If any of the garage stays as storage, the opening needs fire separation, such as a fire door.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.