Steel BeamInstallers
Hallway doorway widened into a larger opening with a new lintel before plastering

Wider doorways & openings · Selkirk

Wider doorways & openings in Selkirk

Steelwork, approvals and making good for wider doorways & openings in Selkirk and nearby.

  • Free survey visit in Selkirk
  • Engineer's calculations arranged
  • Building warrant handled for you

Free survey in Selkirk

Tell us about the wider doorways & opening job in Selkirk.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Wider doorways & openings in Selkirk: how it works

Wider doorways & openings in Selkirk are planned around the house, not a standard kit. We also cover the surrounding towns and villages in the Scottish Borders. We visit, measure and check what the wall carries, then arrange calculations and building warrant before any steel is ordered.

We arrange a survey visit, structural calculations where the wall is load-bearing, building standards, propping, the lintel or beam, new door linings if you want them, and making good. One itemised written quote covers the lot, and the price is fixed in writing once the opening size and finish are agreed.

What to expect

  • Older door surrounds and walls can hide asbestos in textured coatings, insulating board above doors or panelling. In buildings built before 2000 it must be identified before the wall is cut, so a refurbishment survey of the area is arranged where there is a risk.
  • Widening a single doorway in a load-bearing wall usually takes one to two days for the structural work. The plaster then needs time to dry before the door linings are decorated or a new door is hung.
  • Openings are cut with a masonry saw where possible rather than broken out with a hammer. Clean cuts keep the brickwork either side sound, give a straighter edge for plastering and send less vibration through the rest of the wall.
  • For a modest increase in width, a lintel may be all that is needed, while a wider opening carrying a floor or wall usually needs steel. The engineer chooses the type and size from the actual loads, never from the opening width alone.
  • Hallway walls are often load-bearing because they line up with walls upstairs and carry the floor joists or the stairs. A wall that sounds hollow when knocked is usually a stud partition, but older homes can have timber walls that still carry loads, so the engineer checks.

What happens, step by step

  1. Survey in Selkirk

    We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.

  2. Engineer's design

    A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.

  3. Building warrant

    A building warrant is applied for from Scottish Borders Council, and work starts only once the warrant has been granted.

  4. Install and sign-off

    Props go in, the opening is formed, the steel is set and packed, building standards inspects it, and we make good.

How much should I budget in Selkirk?

As a guide, budget £910–£2,280 including VAT for widening an internal doorway in Selkirk, based on published UK cost guides adjusted for prices in Scotland (-9%).

JobTypical guide rangeWhat it usually covers
Widening an internal doorway£910–£2,280Opening widened with a new lintel or short beam, approval where structural, and making good
Structural calculations for a beam£230–£680Site measure or photos, beam and padstone design and calculations for building standards
Building warrant fee£215–£435Statutory fee set by the estimated value of the work: £215 up to £5,000, rising on a sliding scale (fees from 1 April 2026)
RSJ supply and fit (single beam)£730–£2,280 per beamBeam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately)

Figures include our approximate regional adjustment for prices in Scotland (-9%) and are rounded. How these figures are worked out.

Building rules for Selkirk

In Scotland, structural alterations need a building warrant under the Building (Scotland) Act 2003, and work must not start until the warrant is granted. For Selkirk, warrants are handled by Scottish Borders Council's building standards service. When the work is finished, a completion certificate is submitted and has to be accepted by the council.

Scotland has no Party Wall Act. Work affecting a shared wall is governed by your title deeds and the general law, and in flats by the Tenements (Scotland) Act 2004, so it is sensible to agree the work with neighbours in writing before starting.

Building rules in Scotland

Wider doorways & openings near Selkirk

Wider doorways & openings in Selkirk: your questions

Do you cover Selkirk for wider doorways & openings?

Yes. We carry out wider doorways & openings in Selkirk and the TD7 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

Can I stay at home while the work is done in Selkirk?

Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.

How wide can I make a doorway?

That depends on the wall, what it carries and how much solid wall is left at each side for the support to bear on, and a structural engineer sets the limit. Many people go from a single door to a double-width opening, and beyond that the job starts to become a partial wall removal.

Is a lintel or a steel beam needed for a wider door?

It depends on the loads. A lintel can be enough for a modest widening under light loads, while an opening carrying floor joists or a wall above usually needs steel. The engineer decides from the actual loads and span rather than the width alone, and we fit whichever is specified.

Do I need building regulations to widen an internal door?

Only if the wall is load-bearing or the change affects fire safety, such as the escape route from upstairs. Widening an opening in a non-structural stud partition usually does not need structural approval. We confirm which applies at the survey, and handle the building standards application or notice where it is needed.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.