Through-lounge knock-throughs · New Milton
Through-lounge knock-throughs in New Milton
Through-lounge knock-throughs in New Milton, from free survey to completion certificate.
- Survey, design and installation in one
- Covering BH25
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
What through-lounge knock-throughs involve in New Milton
For homes in New Milton and the BH25 district, we handle through-lounge knock-throughs from survey to sign-off. We also work in nearby Bournemouth, roughly 9.7 miles away. The beam is sized by a structural engineer and inspected before it is boxed in.
Many period terraces and semis were built with a front parlour and a back sitting room divided by a solid brick wall. Opening them into one through-lounge brings light from both ends of the house, but that wall commonly carries the floor joists, the wall between the bedrooms above and sometimes part of the roof load too.
Worth knowing before you start
- Victorian brickwork is usually laid in soft lime mortar and the internal walls may be only one brick thick. The engineer allows for this when designing the bearings, and padstones are often used to spread the beam's load over the weaker masonry.
- With the wall gone, the floorboards on each side may run in different directions or sit at slightly different heights. Matching reclaimed boards can be fitted across the old wall line, or the floor can be levelled for a new continuous finish.
- Period ceilings are often lath and plaster, which can crack or sag when the wall below is disturbed. Props are set to spread load gently, and damaged areas are repaired with lime plaster or overboarded, depending on the condition and your preference.
- Radiators, pipe runs and sockets on the dividing wall need relocating. Older houses sometimes have heating pipes running under the floor along the wall line, so these are traced and moved by a heating engineer before the wall comes down.
- Many owners leave short nibs of wall at each end of the opening rather than going fully wall to wall. Nibs can give the beam a bearing, line up with the chimney breasts and keep the feel of two linked rooms, but the engineer decides whether they are adequate.
Four stages, one team
Free visit
A short visit to New Milton to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
How much should I budget in New Milton?
As a guide, budget £2,800–£6,150 including VAT for through-lounge knock-through in New Milton, based on published UK cost guides adjusted for prices in the South East (+12%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Through-lounge knock-through | £2,800–£6,150 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Temporary works and propping | £170–£560 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Chimney breast removal (ground floor) | £1,700–£3,350 | Ground-floor breast removed, steel to support the breast above, building control and making good |
| Load-bearing wall removal with steel beam | £2,250–£5,600 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.
Approvals in New Milton
In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either the local council's building control team or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Through-lounge knock-throughs near New Milton
- Christchurch 5.2 mi
- Bournemouth 9.7 mi
- Hythe 13.6 mi
- Totton 13.6 mi
- Poole 14.2 mi
- Southampton 15.3 mi
Questions about through-lounge knock-throughs in New Milton
Do you also work near New Milton?
Yes. We also cover nearby towns including Christchurch, Bournemouth, Hythe and Totton.
Can you work on older or listed homes in New Milton?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
Should I keep the chimney breasts when knocking through?
Most people do, because the breasts frame the opening and support the stack above. Removing a chimney breast is a separate structural job needing its own design and approval, and it affects your neighbour if the stack is shared. Keeping them usually simplifies the steelwork and preserves the character of the room.
Can I keep the cornicing when the wall comes down?
Usually yes. The existing cornice in each room is protected during the work, and a matching profile can be run or cast to bridge the opening once the beam is boxed and plastered. How closely it matches depends on the original design and its condition, which we check at the survey visit.
Can I knock my front and back rooms into one?
Yes, in most houses. The dividing wall is usually load-bearing, so a structural engineer designs a steel beam to carry the floor and wall above, and building control approves the work. In terraces and semis the beam often bears into the party wall, which in England and Wales means serving a party wall notice before work starts.
Do you cover New Milton for through-lounge knock-throughs?
Yes. We carry out through-lounge knock-throughs in New Milton and the BH25 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.