Steel BeamInstallers
Victorian through-lounge with a boxed beam where the dividing wall used to be

Through-lounge knock-throughs · Gerrards Cross

Through-lounge knock-throughs in Gerrards Cross

Through-lounge knock-throughs in Gerrards Cross, from free survey to completion certificate.

  • Survey, design and installation in one
  • Covering SL9, UB9
  • Inspected before it is covered

Free survey in Gerrards Cross

Tell us about the through-lounge knock-through job in Gerrards Cross.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

Planning through-lounge knock-throughs in Gerrards Cross

For homes in Gerrards Cross and the SL9 and UB9 districts, we handle through-lounge knock-throughs from survey to sign-off. It sits about 5.6 miles from Slough, which we also cover. The beam is sized by a structural engineer and inspected before it is boxed in.

Many period terraces and semis were built with a front parlour and a back sitting room divided by a solid brick wall. Opening them into one through-lounge brings light from both ends of the house, but that wall commonly carries the floor joists, the wall between the bedrooms above and sometimes part of the roof load too.

Things to plan for

  • Period ceilings are often lath and plaster, which can crack or sag when the wall below is disturbed. Props are set to spread load gently, and damaged areas are repaired with lime plaster or overboarded, depending on the condition and your preference.
  • In most terraced houses the wall between the front and back rooms runs across the house and carries the floor above, plus the wall between the front and back bedrooms. It is normally load-bearing, but the engineer still checks before any design is drawn up.
  • Victorian brickwork is usually laid in soft lime mortar and the internal walls may be only one brick thick. The engineer allows for this when designing the bearings, and padstones are often used to spread the beam's load over the weaker masonry.
  • Many owners leave short nibs of wall at each end of the opening rather than going fully wall to wall. Nibs can give the beam a bearing, line up with the chimney breasts and keep the feel of two linked rooms, but the engineer decides whether they are adequate.
  • With the wall gone, the floorboards on each side may run in different directions or sit at slightly different heights. Matching reclaimed boards can be fitted across the old wall line, or the floor can be levelled for a new continuous finish.

Four stages, one team

  1. Survey in Gerrards Cross

    We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.

  2. Engineer's design

    A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.

  3. Building control

    We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.

  4. Install and sign-off

    Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.

How much should I budget in Gerrards Cross?

As a guide, budget £2,800–£6,150 including VAT for through-lounge knock-through in Gerrards Cross, based on published UK cost guides adjusted for prices in the South East (+12%).

JobTypical guide rangeWhat it usually covers
Through-lounge knock-through£2,800–£6,150Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill
Chimney breast removal (ground floor)£1,700–£3,350Ground-floor breast removed, steel to support the breast above, building control and making good
Load-bearing wall removal with steel beam£2,250–£5,600Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good
Kitchen-diner knock-through£2,800–£6,700Internal structural wall between kitchen and dining room, steel beam, approvals and making good (kitchen fitting extra)

Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.

Building rules for Gerrards Cross

For Gerrards Cross, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.

Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.

Building rules in England

Through-lounge knock-throughs near Gerrards Cross

Through-lounge knock-throughs in Gerrards Cross: your questions

Who approves through-lounge knock-throughs in Gerrards Cross?

Structural work in Gerrards Cross needs a building notice or full plans application to the local council's building control team or a registered building control approver. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.

Do you cover Gerrards Cross for through-lounge knock-throughs?

Yes. We carry out through-lounge knock-throughs in Gerrards Cross and the SL9 and UB9 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

How wide can a through-lounge opening be?

That depends on what the wall carries and how the beam ends can be supported, and the structural engineer sets it. Many owners go nearly full width, keeping short nibs at each end, while others choose a narrower opening to keep two distinct rooms. Wider spans need heavier steel and sometimes columns.

Can I keep the cornicing when the wall comes down?

Usually yes. The existing cornice in each room is protected during the work, and a matching profile can be run or cast to bridge the opening once the beam is boxed and plastered. How closely it matches depends on the original design and its condition, which we check at the survey visit.

Do I need consent to knock through in a listed building?

Yes, you need both listed building consent and building regulations approval. Listed building consent from the local planning authority covers internal structural changes to the building's fabric, and building control covers the structural safety. Carrying out works to a listed building without consent is an offence, so it must be in place before anything is booked.

Do you also work near Gerrards Cross?

Yes. We also cover nearby towns including Chalfont St Peter, Uxbridge, Rickmansworth and Slough.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.