Steel BeamInstallers
Adjustable steel props and needles supporting a brick wall before an opening is formed

Temporary works & propping · Pitlochry

Temporary works & propping in Pitlochry

Steelwork, approvals and making good for temporary works & propping in Pitlochry and nearby.

  • Price fixed in writing once scope is agreed
  • Building warrant arranged
  • Temporary works and making good included

Free survey in Pitlochry

Tell us about the temporary works & propping job in Pitlochry.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

What temporary works & propping involve in Pitlochry

Planning temporary works & propping in Pitlochry? Our team covers PH9 and PH16 and the streets around them. Our coverage runs across Perth and Kinross, so nearby villages are included too. You get one written quote for the calculations, approvals, propping, steel and making good.

Propping is included in every structural job we quote, and we can also provide it as a separate service where a wall, lintel or chimney needs supporting while other work goes on. The layout of props, needles and spreaders follows the engineer's calculations or a temporary works design for the job.

Things to plan for

  • Needle holes leave neat square gaps in the wall above the new beam. Once the props are out, these are filled with brick or block and mortar, then plastered over with the rest of the making good.
  • For simple openings, the engineer's calculations usually show the propping arrangement. Larger or unusual jobs, such as removing several walls or working beneath chimney stacks, may need a separate temporary works design prepared by an engineer.
  • Typical mistakes include props standing on unsupported floorboards, missing spreaders so one joist takes all the load, and props wound up too hard so the ceiling lifts and cracks. Careful setting out and gradual tightening avoid all three.
  • Every prop delivers a concentrated load that has to go somewhere. Before any are set up, the floor beneath is checked, because a suspended timber floor or a thin slab may not take that load without extra support carried down to the ground.
  • In the UK, temporary works are generally managed following BS 5975, the code of practice for temporary works procedures. On bigger jobs that means a named coordinator, a written design and checks before props are loaded or taken out.

Four stages, one team

  1. Free visit

    A short visit to Pitlochry to see the job, agree what you want and check the bearings, floors and services that affect the design.

  2. Calculations

    The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.

  3. Building warrant

    A building warrant is applied for from Perth and Kinross Council, and work starts only once the warrant has been granted.

  4. Steel in, made good

    On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.

What do temporary works & propping cost in Pitlochry?

As a guide, budget £140–£460 including VAT for temporary works and propping in Pitlochry, based on published UK cost guides adjusted for prices in Scotland (-9%).

JobTypical guide rangeWhat it usually covers
Temporary works and propping£140–£460Props, spreaders, needles and sole plates for a typical opening, installed and struck
Structural calculations for a beam£230–£680Site measure or photos, beam and padstone design and calculations for building standards
Load-bearing wall removal with steel beam£1,800–£4,550Typical internal wall up to about 4 m: calculations, building standards, propping, steel, padstones, fitting, fire protection and making good

Figures include our approximate regional adjustment for prices in Scotland (-9%) and are rounded. How these figures are worked out.

Approvals in Pitlochry

In Scotland, structural alterations need a building warrant under the Building (Scotland) Act 2003, and work must not start until the warrant is granted. For Pitlochry, warrants are handled by Perth and Kinross Council's building standards service. When the work is finished, a completion certificate is submitted and has to be accepted by the council.

There is no party wall notice system in Scotland. Instead, check your title deeds and, for flats, the tenement management scheme, and talk to neighbours early if the beam bears into a shared wall.

Building rules in Scotland

Temporary works & propping near Pitlochry

Temporary works & propping in Pitlochry: your questions

Do you cover Pitlochry for temporary works & propping?

Yes. We carry out temporary works & propping in Pitlochry and the PH9 and PH16 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

Can you work on older or listed homes in Pitlochry?

Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.

Can I hire props and support a wall myself?

Props can be hired, but propping a structure is skilled work with serious consequences if it goes wrong. The arrangement should come from an engineer's design, and the loads, floor strength and sequence all need checking. Structural propping should be left to a competent team working to that design.

Why do you need props to remove a wall?

Because the wall is holding up weight that still has to be supported while it is gone. Props and needles carry the floors, walls or roof above down to the ground until the new steel beam is fitted, packed and taking the load. Without them, the structure above could drop, crack or, at worst, collapse.

Do I need a temporary works design for my job?

Not always. For a simple single opening, the propping shown in the engineer's calculations is often enough. Bigger or more complex jobs, such as removing several walls, supporting chimney stacks or replacing a shopfront beam, may need a separate temporary works design from an engineer, following the BS 5975 approach.

Who approves temporary works & propping in Pitlochry?

Structural work in Pitlochry needs a building warrant from Perth and Kinross Council, granted before work starts. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.