Temporary works & propping · Mid and East Antrim
Temporary works & propping in Mid and East Antrim
Survey, engineer's design and installation of temporary works & propping anywhere in Mid and East Antrim.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our temporary works & propping service in Mid and East Antrim
Temporary works and propping are the short-term supports that carry floors, walls and roof loads while a structural wall is taken out or a beam is put in. Adjustable steel props, timber spreaders and steel needles pass the weight safely down to the ground until the permanent steel is installed, packed tight and able to take the load itself.
Temporary works & propping in Mid and East Antrim follows the same careful process wherever the property is: a survey, an engineer's design, the right approval and safe temporary works. That includes Larne, Carrickfergus and Ballymena, plus smaller towns and villages nearby. We price it all up front so there are no surprises once the wall is open.
Key points for your project
- For simple openings, the engineer's calculations usually show the propping arrangement. Larger or unusual jobs, such as removing several walls or working beneath chimney stacks, may need a separate temporary works design prepared by an engineer.
- Typical mistakes include props standing on unsupported floorboards, missing spreaders so one joist takes all the load, and props wound up too hard so the ceiling lifts and cracks. Careful setting out and gradual tightening avoid all three.
- On larger jobs, a temporary works register or permit records when the props were installed, inspected, loaded and removed. It creates a clear trail showing each stage was checked before the next one began.
- Needle holes leave neat square gaps in the wall above the new beam. Once the props are out, these are filled with brick or block and mortar, then plastered over with the rest of the making good.
- Props take up floor space for the length of the job, usually in the rooms on both sides of the wall. Furniture needs moving back, and nobody else in the house should knock, adjust or hang anything from the props.
From survey to sign-off in Mid and East Antrim
Free visit
A short visit to Mid and East Antrim to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
A full plans application or building notice goes to Mid and East Antrim Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
How much should I budget in Mid and East Antrim?
As a guide, budget £130–£430 including VAT for temporary works and propping in Mid and East Antrim, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Temporary works and propping | £130–£430 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Structural calculations for a beam | £220–£640 | Site measure or photos, beam and padstone design and calculations for building control |
| RSJ supply and fit (single beam) | £690–£2,150 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
| Load-bearing wall removal with steel beam | £1,700–£4,300 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building rules for Mid and East Antrim
Building control in Mid and East Antrim is run by Mid and East Antrim Borough Council. Beams and new openings are controlled work under the Northern Ireland regulations, so we apply before anything is removed and the steel is inspected before it is covered.
The Party Wall etc. Act does not extend to Northern Ireland. Shared walls are dealt with under your title and the general law, so we recommend agreeing access and the work with your neighbour before it starts.
Temporary works & propping by town
Questions about temporary works & propping in Mid and East Antrim
What happens at the survey visit in Mid and East Antrim?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Who approves temporary works & propping in Mid and East Antrim?
Structural work in Mid and East Antrim needs a full plans application or building notice to Mid and East Antrim Borough Council. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
What is needling a wall?
Needling means cutting holes through a wall just above where an opening will go and passing short steel beams, called needles, through them. Each needle is supported on props on both sides, so the masonry above rests on the needles while the wall below is removed and the permanent beam is fitted.
Why do you need props to remove a wall?
Because the wall is holding up weight that still has to be supported while it is gone. Props and needles carry the floors, walls or roof above down to the ground until the new steel beam is fitted, packed and taking the load. Without them, the structure above could drop, crack or, at worst, collapse.
Can I hire props and support a wall myself?
Props can be hired, but propping a structure is skilled work with serious consequences if it goes wrong. The arrangement should come from an engineer's design, and the loads, floor strength and sequence all need checking. Structural propping should be left to a competent team working to that design.
How long do props have to stay in after a beam is fitted?
Until the permanent steel is packed tight and able to carry the load. That includes time for the padstone and packing mortar to gain enough strength, which depends on the mix and the weather. On a typical opening, props are in for a few days before being released gradually.
Which towns in Mid and East Antrim do you cover?
We cover towns including Carrickfergus, Ballymena and Larne, plus the villages and smaller towns around them.