Temporary works & propping · Lisburn and Castlereagh
Temporary works & propping in Lisburn and Castlereagh
Temporary works & propping across Lisburn and Castlereagh, designed by a structural engineer and signed off by building control.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning temporary works & propping in Lisburn and Castlereagh
Temporary works and propping are the short-term supports that carry floors, walls and roof loads while a structural wall is taken out or a beam is put in. Adjustable steel props, timber spreaders and steel needles pass the weight safely down to the ground until the permanent steel is installed, packed tight and able to take the load itself.
From the first survey visit to the completion certificate, we take care of temporary works & propping across Lisburn and Castlereagh. Coverage takes in Lisburn and everywhere in between. The engineer sizes the steel, we deal with Lisburn and Castlereagh City Council, and our team fits and packs the beam before making good.
Things to plan for
- Needle holes leave neat square gaps in the wall above the new beam. Once the props are out, these are filled with brick or block and mortar, then plastered over with the rest of the making good.
- The order of work matters. Props go in and are tightened before any masonry is cut, the opening is formed in stages, and the props stay until the permanent steel is packed tight and the bedding mortar has gained enough strength.
- For simple openings, the engineer's calculations usually show the propping arrangement. Larger or unusual jobs, such as removing several walls or working beneath chimney stacks, may need a separate temporary works design prepared by an engineer.
- Every prop delivers a concentrated load that has to go somewhere. Before any are set up, the floor beneath is checked, because a suspended timber floor or a thin slab may not take that load without extra support carried down to the ground.
- On larger jobs, a temporary works register or permit records when the props were installed, inspected, loaded and removed. It creates a clear trail showing each stage was checked before the next one began.
What happens, step by step
Survey in Lisburn and Castlereagh
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
A full plans application or building notice goes to Lisburn and Castlereagh City Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
What do temporary works & propping cost in Lisburn and Castlereagh?
As a guide, budget £130–£430 including VAT for temporary works and propping in Lisburn and Castlereagh, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Temporary works and propping | £130–£430 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Structural calculations for a beam | £220–£640 | Site measure or photos, beam and padstone design and calculations for building control |
| Lintel replacement | £340–£1,030 per lintel | Propping, removing the old lintel, new lintel set on beds and brickwork made good |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building control and neighbours in Lisburn and Castlereagh
Building control in Lisburn and Castlereagh is run by Lisburn and Castlereagh City Council. Beams and new openings are controlled work under the Northern Ireland regulations, so we apply before anything is removed and the steel is inspected before it is covered.
Northern Ireland has no Party Wall Act, so there is no statutory notice to serve. Where the steel bears into a shared wall, the title deeds and the general law apply, and agreeing the work with your neighbour in writing first is good practice.
Temporary works & propping by town
Local questions answered
What happens at the survey visit in Lisburn and Castlereagh?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Who approves temporary works & propping in Lisburn and Castlereagh?
Structural work in Lisburn and Castlereagh needs a full plans application or building notice to Lisburn and Castlereagh City Council. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
Why do you need props to remove a wall?
Because the wall is holding up weight that still has to be supported while it is gone. Props and needles carry the floors, walls or roof above down to the ground until the new steel beam is fitted, packed and taking the load. Without them, the structure above could drop, crack or, at worst, collapse.
Do I need a temporary works design for my job?
Not always. For a simple single opening, the propping shown in the engineer's calculations is often enough. Bigger or more complex jobs, such as removing several walls, supporting chimney stacks or replacing a shopfront beam, may need a separate temporary works design from an engineer, following the BS 5975 approach.
Can I stay in my house while it is propped?
Usually, yes. The props take up space in the rooms either side of the work, so those rooms will be out of use, but the rest of the house can be lived in as normal. The props must never be moved, knocked or adjusted by anyone other than the installation team.
How long do props have to stay in after a beam is fitted?
Until the permanent steel is packed tight and able to carry the load. That includes time for the padstone and packing mortar to gain enough strength, which depends on the mix and the weather. On a typical opening, props are in for a few days before being released gradually.