Steel BeamInstallers
Two retail units opened into one with a steel beam and columns

Shop & commercial openings · Kirkby

Shop & commercial openings in Kirkby

Shop & commercial openings for homes in L32, L33, designed by a structural engineer.

  • Survey, design and installation in one
  • Covering L32, L33
  • Inspected before it is covered

Free survey in Kirkby

Tell us about the shop & commercial opening job in Kirkby.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

About our shop & commercial openings service in Kirkby

Need shop & commercial openings in Kirkby? It sits about 6.0 miles from Liverpool, which we also cover. We survey the property, arrange the engineer's design, deal with Knowsley Council, fit the steel and make good, all under one quote for L32 and L33 addresses.

Commercial buildings often have a flat or offices above the shop, a heavy brick front and old steel or timber over the existing shopfront. Opening them up means supporting a lot of load at street level, usually with the public walking past, while keeping disruption to trading as low as possible.

Key points for your project

  • Structural alterations to commercial premises need building regulations approval just as homes do, and in Scotland a building warrant before work starts. In England they usually go through a full plans application, because fire safety is assessed alongside the structure.
  • Many shopfronts sit under an old steel or timber beam hidden behind the fascia for decades. It may be corroded, undersized for what is above or bearing on decayed masonry, so it is opened up and checked before keeping it is even considered.
  • Commercial buildings built before 2000 should already have an asbestos register under the duty to manage. Before walls or ceilings are opened up, the register is checked and a refurbishment survey of the work area is arranged where it does not cover the job.
  • Where there is a flat above the shop, its occupants need to know about the works and their safety has to be protected. Their access, fire escape route and the structure holding up their floor must all be maintained throughout the job.
  • The main cost factors are the span and load above, whether columns or a goalpost frame are needed, the temporary works at the street, out-of-hours working, lifting equipment, and the fire protection and finish the opening requires.

Four stages, one team

  1. Survey in Kirkby

    We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.

  2. Engineer's design

    A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.

  3. Building control

    We submit a building notice or full plans application to Knowsley Council, so approval is in place before the wall is touched.

  4. Install and sign-off

    Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.

How much should I budget in Kirkby?

As a guide, budget £4,800–£14,400 including VAT for shop or commercial structural opening in Kirkby, based on published UK cost guides adjusted for prices in the North West (-4%).

JobTypical guide rangeWhat it usually covers
Shop or commercial structural opening£4,800–£14,400Transfer beam and columns for opening units together or forming a shopfront opening
Temporary works and propping£140–£480Props, spreaders, needles and sole plates for a typical opening, installed and struck
Fire protection to a steel beam£140–£580 per beamFire-rated board boxing or an intumescent coating system as specified
Steel goalpost frame£1,900–£5,750Two posts and a beam bolted as a frame, pad foundations, base plates and fitting

Figures include our approximate regional adjustment for prices in the North West (-4%) and are rounded. How these figures are worked out.

Building rules for Kirkby

In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either Knowsley Council or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.

Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.

Building rules in England

Shop & commercial openings near Kirkby

Local questions answered

Do you cover Kirkby for shop & commercial openings?

Yes. We carry out shop & commercial openings in Kirkby and the L32 and L33 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

What happens at the survey visit in Kirkby?

We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.

Do I need my landlord's permission to put in a steel beam?

Almost certainly, if you lease the premises. Most commercial leases forbid structural alterations without the landlord's written consent, usually given as a licence for alterations. We can supply the engineer's calculations and drawings your landlord asks for, though the lease terms themselves are a matter for you and your solicitor.

Can commercial steel beam work be done outside opening hours?

In many cases, yes. Noisy cutting and the main structural stages can be programmed for evenings, early mornings or weekends where the landlord, the building and neighbouring occupiers allow. Out-of-hours working is priced as a separate line on the itemised quote, so you can weigh it against closing for part of the job.

Can I knock two shops into one?

Usually, yes, with the right approvals. The dividing wall is replaced with steel designed by a structural engineer, building control approves the work and the fire strategy is updated for the combined unit. You also need landlord consent if you lease either unit, and party wall notices in England and Wales if the steel bears into a wall shared with another owner.

Do you also work near Kirkby?

Yes. We also cover nearby towns including Maghull, Litherland, Prescot and Bootle.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.