Shop & commercial openings · Andover
Shop & commercial openings in Andover
Shop & commercial openings in Andover, from free survey to completion certificate.
- Survey, design and installation in one
- Covering SP10, SP11
- Inspected before it is covered
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning shop & commercial openings in Andover
Need shop & commercial openings in Andover? We also cover the surrounding towns and villages in Hampshire. We survey the property, arrange the engineer's design, deal with local building control, fit the steel and make good, all under one quote for SP10 and SP11 addresses.
We carry out structural openings for small commercial premises across the UK, working to an engineer's design and handling building control. Work can be planned around opening hours, including out-of-hours shifts where the landlord and building allow, and coordinated with your shopfitter.
Things to plan for
- Commercial premises often have three-phase power, alarm and data cabling, gas supplies and drainage running through the walls being altered. These are mapped at the survey, and any work on gas pipes must by law be done by a Gas Safe registered engineer.
- Joining two units can change the fire strategy. The wall between them may be a compartment wall, escape routes and travel distances alter, and the steel needs fire protection to the required period. The fire risk assessment should be updated to match the new layout.
- Many shopfronts sit under an old steel or timber beam hidden behind the fascia for decades. It may be corroded, undersized for what is above or bearing on decayed masonry, so it is opened up and checked before keeping it is even considered.
- Shop buildings commonly have a full-height brick wall above the shopfront carrying upper floors and the roof. The engineer designs for that load, plus any point loads from chimney stacks or columns, and may specify a compound section or a steel frame.
- Purely internal works may not need planning permission, but a new or altered shopfront changes the look of the building and may need it, particularly in a conservation area. Listed commercial buildings also need listed building consent for structural changes.
What happens, step by step
Survey in Andover
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for shop & commercial openings in Andover
As a guide, budget £5,600–£16,800 including VAT for shop or commercial structural opening in Andover, based on published UK cost guides adjusted for prices in the South East (+12%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Shop or commercial structural opening | £5,600–£16,800 | Transfer beam and columns for opening units together or forming a shopfront opening |
| Fire protection to a steel beam | £170–£670 per beam | Fire-rated board boxing or an intumescent coating system as specified |
| Temporary works and propping | £170–£560 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Steel goalpost frame | £2,250–£6,700 | Two posts and a beam bolted as a frame, pad foundations, base plates and fitting |
Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.
Building rules for Andover
For Andover, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Shop & commercial openings near Andover
- Winchester 12.6 mi
- Newbury 15.0 mi
- Salisbury 16.4 mi
- Thatcham 16.7 mi
- Basingstoke 18.0 mi
- Eastleigh 18.0 mi
Shop & commercial openings in Andover: your questions
Do you cover Andover for shop & commercial openings?
Yes. We carry out shop & commercial openings in Andover and the SP10 and SP11 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.
Can I stay at home while the work is done in Andover?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.
Do I need planning permission for a new shop front?
Often, yes. A new or altered shopfront usually changes how the building looks from the street, which can need planning permission, especially in a conservation area. Purely internal openings generally do not, but listed buildings need listed building consent for structural changes inside or out. It is worth checking with the local planning authority early.
Do I need my landlord's permission to put in a steel beam?
Almost certainly, if you lease the premises. Most commercial leases forbid structural alterations without the landlord's written consent, usually given as a licence for alterations. We can supply the engineer's calculations and drawings your landlord asks for, though the lease terms themselves are a matter for you and your solicitor.
Do I need an asbestos survey before work on my shop?
Usually, if the building dates from before 2000. The duty holder for commercial premises should already have an asbestos register, and before walls, ceilings or the shopfront are opened up, a refurbishment survey of the work area is needed wherever that register does not cover it, so any asbestos is dealt with first.