Steel BeamInstallers
Two installers seen from behind lifting a steel beam onto a padstone

RSJ installation · Larne

RSJ installation in Larne

Steelwork, approvals and making good for RSJ installation in Larne and nearby.

  • Itemised written quote
  • Beam sized by a structural engineer
  • Covering Larne and nearby

Free survey in Larne

Tell us about the RSJ installation job in Larne.

Please enter your name.
Please enter a UK phone number.
Please enter a valid email.
Please enter a UK postcode.
Please tell us a little about the job.
  • Free survey visit
  • Engineer's calculations arranged
  • Building control handled
  • Fixed written price once scope is agreed
  • England, Wales, mainland Scotland & NI

RSJ installation in Larne: how it works

We cover RSJ installation in Larne (BT40) and the streets around it. Our coverage runs across Mid and East Antrim, so nearby villages are included too. Each job is designed by a structural engineer and approved through Mid and East Antrim Borough Council before work begins.

We supply and fit the steel from start to finish. That includes arranging the calculations, having the beam fabricated with the right end plates, holes and primer, getting it into the property, setting it on its bearings, and packing it so it takes the load. Building control, propping and making good sit in the same itemised quote.

What to expect

  • Packing is what makes the beam work. Steel shims and dry-pack mortar fill the gap between the top flange and the structure above, so the load transfers onto the steel without the floor or wall settling down onto it.
  • Padstones spread the concentrated load from each beam end into the masonry below. They may be concrete, engineering brick or a steel plate, depending on the engineer's design and the strength of the wall beneath.
  • Floor joists can rest on the bottom flange, hang from timber packers bolted into the web, or be notched to sit over the steel. The engineer specifies the connection, and it affects how flush the finished ceiling can be.
  • Structural steel comes in recognised grades, and the engineer's drawing states which grade the calculations assume. The steel supplied matches that specification, and the delivery paperwork is kept so building control can see what has been fitted.
  • Delivery can make or break an RSJ job. A long beam has to turn through a front door, along a hallway and past the stairs, so routes are measured at the survey and alternatives such as a window opening are planned early.

What happens, step by step

  1. Free visit

    A short visit to Larne to see the job, agree what you want and check the bearings, floors and services that affect the design.

  2. Calculations

    The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.

  3. Building control

    A full plans application or building notice goes to Mid and East Antrim Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.

  4. Steel in, made good

    On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.

Guide prices for RSJ installation in Larne

As a guide, budget £690–£2,150 per beam including VAT for rSJ supply and fit (single beam) in Larne, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).

JobTypical guide rangeWhat it usually covers
RSJ supply and fit (single beam)£690–£2,150 per beamBeam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately)
Structural calculations for a beam£220–£640Site measure or photos, beam and padstone design and calculations for building control
Fire protection to a steel beam£130–£520 per beamFire-rated board boxing or an intumescent coating system as specified
Load-bearing wall removal with steel beam£1,700–£4,300Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good

Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.

Building rules for Larne

In Northern Ireland, structural work comes under the Building Regulations (Northern Ireland) 2012 and is approved by the local council's building control. For Larne that is Mid and East Antrim Borough Council. We submit a full plans application or building notice before work starts and book the inspections.

Northern Ireland has no Party Wall Act, so there is no statutory notice to serve. Where the steel bears into a shared wall, the title deeds and the general law apply, and agreeing the work with your neighbour in writing first is good practice.

Building rules in Northern Ireland

RSJ installation near Larne

RSJ installation in Larne: your questions

Do you cover Larne for RSJ installation?

Yes. We carry out RSJ installation in Larne and the BT40 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.

What happens at the survey visit in Larne?

We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.

Can an RSJ be delivered in sections?

Yes, where access is tight. The engineer can design bolted splice joints so a long beam arrives in two or more pieces and is joined in place. The splice has to be part of the calculations from the start, because it changes how the beam carries load at that point.

How heavy is an RSJ and how is it lifted?

Weight varies widely with the section and length, from beams a small team can carry to steels needing mechanical lifting. The lift is planned at the survey, using enough people, trolleys and suitable lifting equipment so the beam goes up safely and level onto both bearings.

Can you fit an RSJ to my own engineer's calculations?

Yes. We install to calculations and drawings from your engineer or architect, as long as they cover the beam, bearings and any columns or connections. If site conditions differ from what the design assumed, we check with the engineer before carrying on.

Do you also work near Larne?

Yes. We also cover nearby towns including Carrickfergus, Newtownabbey, Antrim and Ballymena.

Planning to take a wall out?

Book a free survey visit. You get an itemised written quote covering calculations, building control, steel and making good.