Load-bearing wall removal · Andover
Load-bearing wall removal in Andover
Steelwork, approvals and making good for load-bearing wall removal in Andover and nearby.
- Free survey visit in Andover
- Engineer's calculations arranged
- Building control handled for you
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our load-bearing wall removal service in Andover
Need load-bearing wall removal in Andover? Our coverage runs across Hampshire, so nearby villages are included too. We survey the property, arrange the engineer's design, deal with local building control, fit the steel and make good, all under one quote for SP10 and SP11 addresses.
We handle the whole job: a survey visit, structural calculations from a qualified engineer, building control, temporary propping, the steel itself, and making good afterwards. You get one itemised written quote and one team to deal with from first visit to sign-off.
Key points for your project
- Steel beams in homes usually need fire protection. That is often fire-rated plasterboard boxing, which also gives a neat finish, or intumescent paint where the steel is left on show.
- The beam size depends on the span, what sits above and how the ends are supported. Two walls that look the same can need very different steel, which is why every beam is sized from calculations rather than guessed.
- Older homes can hide surprises such as weak lime mortar, timber lintels or a wall with no proper footing. Where the engineer needs something extra, we price it before any work starts rather than after.
- Temporary works matter as much as the beam. Props, spreaders and needles carry the house while the wall is out, and they are positioned so the floor below can take them too.
- If the wall carries a chimney breast, a wall upstairs and floor joists all at once, the engineer may specify a heavier beam or two beams side by side. The quote reflects that once calculations are back.
From survey to sign-off in Andover
Free visit
A short visit to Andover to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
What does load-bearing wall removal cost in Andover?
As a guide, budget £2,250–£5,600 including VAT for load-bearing wall removal with steel beam in Andover, based on published UK cost guides adjusted for prices in the South East (+12%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Load-bearing wall removal with steel beam | £2,250–£5,600 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
| Through-lounge knock-through | £2,800–£6,150 | Wall between front and back reception rooms, steel beam, approvals, plastering and floor infill |
| Temporary works and propping | £170–£560 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| RSJ supply and fit (single beam) | £900–£2,800 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
Figures include our approximate regional adjustment for prices in the South East (+12%) and are rounded. How these figures are worked out.
Building control and neighbours in Andover
In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either the local council's building control team or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Load-bearing wall removal near Andover
- Winchester 12.6 mi
- Newbury 15.0 mi
- Salisbury 16.4 mi
- Thatcham 16.7 mi
- Basingstoke 18.0 mi
- Eastleigh 18.0 mi
Load-bearing wall removal in Andover: your questions
What happens at the survey visit in Andover?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Can you work on older or listed homes in Andover?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
What does the price include?
Our written quote is itemised, so you can see the calculations, building control fees, propping, steel, padstones, labour, fire protection and making good set out line by line. The price is fixed in writing once the layout and scope are agreed.
Can I stay in the house while the wall is removed?
In most cases yes. The work area is screened, floors are protected and the house stays usable, though the rooms either side of the wall will be out of action for a few days and there will be some noise and dust.
How long does it take to remove a load-bearing wall?
For a typical house the structural part usually takes two to five working days: propping, taking the wall out, fitting the steel and packing it tight. Plastering and decorating follow once building control has inspected the steel.
Do you cover Andover for load-bearing wall removal?
Yes. We carry out load-bearing wall removal in Andover and the SP10 and SP11 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.