Load-bearing wall removal · Exmouth
Load-bearing wall removal in Exmouth
Steelwork, approvals and making good for load-bearing wall removal in Exmouth and nearby.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Planning load-bearing wall removal in Exmouth
If you live in Exmouth, load-bearing wall removal can usually be planned and priced after a single survey visit. We also work in nearby Exeter, roughly 9.2 miles away. We cover EX8, and we fix the price in writing once the layout and scope are agreed.
Most homes built before the 1970s have at least one internal wall that carries the floor joists, a wall upstairs or part of the roof. Taking it out is very doable, but the weight it carries has to go somewhere. A steel beam picks that load up and passes it down through padstones into walls or columns that can take it.
What to expect
- Cables, pipes, radiators and sometimes gas runs pass through internal walls. These are traced at the survey so they can be rerouted by the right trade before or during the work, not discovered halfway through.
- Expect some dust and noise for a day or two while the wall comes out. We screen the work area, protect floors and sweep up daily, and the rest of the house usually stays usable throughout.
- Whether a wall is load-bearing is not always obvious. Joists running across the wall, a wall directly above, or the wall sitting on a footing in the floor are common clues, but the engineer's check on site is what settles it.
- Each end of the beam needs a solid bearing. Padstones spread the point load into the masonry below, and if the wall underneath is weak the engineer may call for a steel column or a new pad foundation instead.
- Temporary works matter as much as the beam. Props, spreaders and needles carry the house while the wall is out, and they are positioned so the floor below can take them too.
How the job runs in Exmouth
Survey in Exmouth
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to the local council's building control team, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for load-bearing wall removal in Exmouth
As a guide, budget £2,050–£5,150 including VAT for load-bearing wall removal with steel beam in Exmouth, based on published UK cost guides adjusted for prices in the South West (+3%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Load-bearing wall removal with steel beam | £2,050–£5,150 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
| Structural calculations for a beam | £260–£770 | Site measure or photos, beam and padstone design and calculations for building control |
| Building control fees | £260–£670 | Building notice or full plans fee and inspections; varies by council or approver |
| RSJ supply and fit (single beam) | £820–£2,580 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
Figures include our approximate regional adjustment for prices in the South West (+3%) and are rounded. How these figures are worked out.
Approvals in Exmouth
For Exmouth, building control is provided by the local council's building control team, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Local questions answered
Can you work on older or listed homes in Exmouth?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
Do you cover Exmouth for load-bearing wall removal?
Yes. We carry out load-bearing wall removal in Exmouth and the EX8 postcode districts. Book a free survey visit and we will check the wall, arrange the engineer's calculations and send an itemised written quote.
Is a steel beam better than a concrete lintel?
For short openings in some walls a lintel can be enough, but wide openings carrying floors or walls above normally need steel. The engineer chooses whatever does the job properly. Steel is common because it carries a lot of load for its depth.
Do I need planning permission to remove an internal wall?
Usually not, because internal alterations to a house are not normally development needing planning permission. Listed buildings are different and need listed building consent, and flats normally need the freeholder's or landlord's written consent.
What does the price include?
Our written quote is itemised, so you can see the calculations, building control fees, propping, steel, padstones, labour, fire protection and making good set out line by line. The price is fixed in writing once the layout and scope are agreed.