Load-bearing wall removal · Causeway Coast and Glens
Load-bearing wall removal in Causeway Coast and Glens
Calculations, approvals, propping, steel and making good for load-bearing wall removal across Causeway Coast and Glens.
- Price fixed in writing once scope is agreed
- Building control arranged
- Temporary works and making good included
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our load-bearing wall removal service in Causeway Coast and Glens
Load-bearing wall removal means taking out a wall that holds up floors, roof loads or walls above it, and replacing that support with a steel beam sized by a structural engineer. The beam sits on padstones at each end, the weight above is held on temporary props while the wall comes out, and building control inspects the finished work.
Looking for load-bearing wall removal in Causeway Coast and Glens? We can survey in places such as Ballymoney, Portrush and Coleraine and the villages around them. Our teams handle the calculations, the building control approval, the propping and the steel itself, and leave the opening ready for plastering and decoration.
What to expect
- Whether a wall is load-bearing is not always obvious. Joists running across the wall, a wall directly above, or the wall sitting on a footing in the floor are common clues, but the engineer's check on site is what settles it.
- If the wall carries a chimney breast, a wall upstairs and floor joists all at once, the engineer may specify a heavier beam or two beams side by side. The quote reflects that once calculations are back.
- Cables, pipes, radiators and sometimes gas runs pass through internal walls. These are traced at the survey so they can be rerouted by the right trade before or during the work, not discovered halfway through.
- A beam can sit below the ceiling with a small boxed downstand or be set up into the floor void so the ceiling runs flat. A flush beam usually needs more work to the joists and costs more.
- Expect some dust and noise for a day or two while the wall comes out. We screen the work area, protect floors and sweep up daily, and the rest of the house usually stays usable throughout.
Four stages, one team
Free visit
A short visit to Causeway Coast and Glens to see the job, agree what you want and check the bearings, floors and services that affect the design.
Calculations
The engineer's calculations and a simple drawing are prepared for your opening and shared with you before anything is ordered.
Building control
A full plans application or building notice goes to Causeway Coast and Glens Borough Council under the Building Regulations (Northern Ireland) 2012 before work begins.
Steel in, made good
On site we prop, open up, fit and pack the steel, then fire protect, box in and plaster once the inspection is done.
Guide prices for load-bearing wall removal in Causeway Coast and Glens
As a guide, budget £1,700–£4,300 including VAT for load-bearing wall removal with steel beam in Causeway Coast and Glens, based on published UK cost guides adjusted for prices in Northern Ireland (-14%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Load-bearing wall removal with steel beam | £1,700–£4,300 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
| Temporary works and propping | £130–£430 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
| Building control fees | £220–£560 | Building notice or full plans fee and inspections; varies by council or approver |
| RSJ supply and fit (single beam) | £690–£2,150 per beam | Beam supplied, delivered, lifted and packed on padstones, with propping (calculations and approval priced separately) |
Figures include our approximate regional adjustment for prices in Northern Ireland (-14%) and are rounded. How these figures are worked out.
Building control and neighbours in Causeway Coast and Glens
Building control in Causeway Coast and Glens is run by Causeway Coast and Glens Borough Council. Beams and new openings are controlled work under the Northern Ireland regulations, so we apply before anything is removed and the steel is inspected before it is covered.
Northern Ireland has no Party Wall Act, so there is no statutory notice to serve. Where the steel bears into a shared wall, the title deeds and the general law apply, and agreeing the work with your neighbour in writing first is good practice.
Load-bearing wall removal by town
Load-bearing wall removal in Causeway Coast and Glens: your questions
What happens at the survey visit in Causeway Coast and Glens?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Which towns in Causeway Coast and Glens do you cover?
We cover towns including Coleraine, Ballymoney, Limavady and Portrush, plus the villages and smaller towns around them.
Is a steel beam better than a concrete lintel?
For short openings in some walls a lintel can be enough, but wide openings carrying floors or walls above normally need steel. The engineer chooses whatever does the job properly. Steel is common because it carries a lot of load for its depth.
How long does it take to remove a load-bearing wall?
For a typical house the structural part usually takes two to five working days: propping, taking the wall out, fitting the steel and packing it tight. Plastering and decorating follow once building control has inspected the steel.
How do I know if my wall is load-bearing?
Clues include floor joists that run across the top of the wall, a wall directly above it upstairs, and a wall that is solid brick or block rather than a hollow stud partition. None of these is proof on its own. A structural engineer checks on site and confirms it before any work is planned.
Who sizes the steel beam?
A structural engineer. They look at the span, the loads from floors, walls and roof above, and the bearings at each end, then specify the beam, padstones and any columns. We arrange those calculations, or work to calculations you already have.
Can I stay at home while the work is done in Causeway Coast and Glens?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.