Lintel replacement · Chippenham
Lintel replacement in Chippenham
Steelwork, approvals and making good for lintel replacement in Chippenham and nearby.
- Free survey visit in Chippenham
- Engineer's calculations arranged
- Building control handled for you
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
About our lintel replacement service in Chippenham
We carry out lintel replacement in Chippenham, covering the SN14 and SN15 postcode districts. Chippenham is around 11.8 miles from Bath, and we cover both. The job starts with a free survey visit so the engineer's calculations are based on your actual walls, floors and loads.
We survey the opening, arrange the engineer's specification and building control, prop the wall, swap the lintel and rebuild the masonry and plaster around it. Your quote is written and itemised, and it covers matching the bricks and mortar as closely as the existing wall allows.
What to expect
- Older steel lintels and bare steel angles can corrode where water sits on them. Rust takes up more room than the steel it comes from, so a corroding lintel can lift the brick course above it and open up horizontal cracks.
- Concrete lintels fail when the steel reinforcement inside rusts and swells, pushing off the concrete face. Rust staining, flaking edges and exposed bars are the warning signs, and once that process is well under way an engineer will often recommend replacement over patching.
- A typical single lintel takes a day or two on site. Keep the building control completion certificate with your property papers, because buyers' surveyors often notice old cracking around openings and their solicitors will ask what was done about it.
- Ground-floor lintels can usually be replaced from the ground with props alone. Openings on upper floors need scaffolding or a tower, which adds time and cost but also gives a safe, stable platform for rebuilding the brickwork neatly.
- Diagonal cracks that start at the top corners of a window and step up through the mortar joints are a classic sign of a lintel problem. Movement elsewhere in a house can cause similar cracks, so the cause is confirmed on site before anything is replaced.
How the job runs in Chippenham
Survey in Chippenham
We visit, look at the wall and what sits above it, measure the opening and note services, access and how the steel can be brought in.
Engineer's design
A structural engineer sizes the beam, padstones and any posts, and sets out the temporary support needed while the wall is out.
Building control
We submit a building notice or full plans application to Wiltshire Council, so approval is in place before the wall is touched.
Install and sign-off
Props go in, the opening is formed, the steel is set and packed, building control inspects it, and we make good.
Guide prices for lintel replacement in Chippenham
As a guide, budget £410–£1,240 per lintel including VAT for lintel replacement in Chippenham, based on published UK cost guides adjusted for prices in the South West (+3%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Lintel replacement | £410–£1,240 per lintel | Propping, removing the old lintel, new lintel set on beds and brickwork made good |
| Structural calculations for a beam | £260–£770 | Site measure or photos, beam and padstone design and calculations for building control |
| Widening an internal doorway | £1,050–£2,600 | Opening widened with a new lintel or short beam, approval where structural, and making good |
| Temporary works and propping | £150–£520 | Props, spreaders, needles and sole plates for a typical opening, installed and struck |
Figures include our approximate regional adjustment for prices in the South West (+3%) and are rounded. How these figures are worked out.
Building control and neighbours in Chippenham
In England, taking out a load-bearing wall or putting in a beam is building work under the Building Regulations 2010. It needs approval from building control, either Wiltshire Council or a registered building control approver, through a full plans application or a building notice. Part A covers the structure and Part B covers fire safety, which is why steel in homes is usually fire protected.
If the beam bears into a wall you share with a neighbour, the Party Wall etc. Act 1996 applies, and a party structure notice must be served at least two months before that work starts. We arrange this through a party wall surveyor.
Lintel replacement near Chippenham
- Trowbridge 10.4 mi
- Bath 11.8 mi
- Yate 13.8 mi
- Swindon 16.3 mi
- Mangotsfield 16.4 mi
- Kingswood 16.5 mi
Local questions answered
Can you work on older or listed homes in Chippenham?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
What happens at the survey visit in Chippenham?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Can a timber lintel in an old house be replaced with steel or concrete?
Yes, where the engineer is satisfied it suits the wall. Timber lintels in older solid-walled homes are often swapped for a steel or concrete alternative that will not rot. The engineer considers how the wall is built, and where lime mortar is present the rebuild uses a compatible mortar.
What type of lintel will be fitted?
The engineer decides, based on the opening width, the wall construction and the load above. Steel lintels are common in cavity walls, while solid walls or wide openings may suit a different type or a steel section. We fit what the specification calls for rather than a one-size option.
Can a lintel be replaced without removing the window?
Often, yes. The brickwork above is propped, the old lintel is taken out and the new one fitted while the frame stays in place under protection. If the frame has been carrying weight because the old lintel sagged, it may need easing or adjusting once the new lintel is in.
Can I stay at home while the work is done in Chippenham?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.