Tyne and Wear · England
Steel beam installers in Gateshead
RSJs and steel beams for homes and businesses in Gateshead, with calculations, approvals, propping and making good.
- Itemised written quote
- Beam sized by a structural engineer
- Covering Gateshead and nearby
- Free survey visit
- Engineer's calculations arranged
- Building control handled
- Fixed written price once scope is agreed
- England, Wales, mainland Scotland & NI
Steel beam work in Gateshead
Homes in Gateshead are covered for all our steel beam services. We also work in nearby Newcastle upon Tyne, roughly 0.9 miles away. Every beam is sized from calculations, approved before work starts and inspected before it is covered.
Approval in Gateshead is through council building control or a registered building control approver, and party wall notices apply where steel bears into a shared wall.
Services in Gateshead
Wall removal & knock-throughs
- Load-bearing wall removal
- Kitchen-diner knock-throughs
- Through-lounge knock-throughs
- Chimney breast removal
New & wider openings
- Wider doorways & openings
- Bi-fold & sliding door openings
- Garage conversion openings
- Lintel replacement
Extensions, lofts & basements
Beams, frames & columns
Design & approvals
- Structural calculations
- Building control sign-off
- Party wall beam works
- Fire protection for steel beams
Site works & commercial
Four stages, one team
Look and measure
We check the wall, the span you want and what the wall is carrying, and photograph anything the engineer needs to see.
Design and price
Calculations come back from the engineer and we confirm your fixed written price, line by line.
Building control
We submit a building notice or full plans application to Gateshead Council, so approval is in place before the wall is touched.
Fit, inspect, finish
The work is propped and the steel installed and packed tight. After inspection the opening is boxed, plastered and left clean.
Guide prices in Gateshead
As a guide, budget £1,850–£4,650 including VAT for load-bearing wall removal with steel beam in Gateshead, based on published UK cost guides adjusted for prices in the North East (-7%).
| Job | Typical guide range | What it usually covers |
|---|---|---|
| Load-bearing wall removal with steel beam | £1,850–£4,650 | Typical internal wall up to about 4 m: calculations, building control, propping, steel, padstones, fitting, fire protection and making good |
| Chimney breast removal (ground floor) | £1,400–£2,800 | Ground-floor breast removed, steel to support the breast above, building control and making good |
| Rear wall opening for bi-fold or sliding doors | £2,300–£6,500 | External wall opened up to about 5 m with steel, propping, cavity tray and making good (doors supplied separately) |
| Loft conversion steels | £2,300–£5,600 | Supply and fit of floor and ridge steels on padstones, including lifting into the roof space |
| Structural calculations for a beam | £230–£700 | Site measure or photos, beam and padstone design and calculations for building control |
Figures include our approximate regional adjustment for prices in the North East (-7%) and are rounded. How these figures are worked out.
Building rules in Gateshead
For Gateshead, building control is provided by Gateshead Council, or by a registered building control approver if preferred. We send them the engineer's calculations with a building notice or full plans application and book the inspections. Work done without approval can cause problems at sale and is far dearer to put right later.
Terraced and semi-detached homes often need party wall notices, because cutting into a shared wall to take a beam end is notifiable under the Party Wall etc. Act 1996. Allow at least two months for the notice period unless your neighbour agrees sooner.
Steel beams in Gateshead: questions
Can I stay at home while the work is done in Gateshead?
Usually, yes. The work area is screened and floors are protected. The rooms either side of the opening are out of action for a few days, and there is some noise and dust while the masonry comes out.
Can you work on older or listed homes in Gateshead?
Yes. Older homes often have lime mortar, timber lintels or shallow footings, which the engineer allows for. Listed buildings need listed building consent for internal structural changes as well as building regulations approval, and that must be in place first.
What happens at the survey visit in Gateshead?
We look at the wall, the floor and ceiling either side and what sits above, measure the opening you want, and note cables, pipes and access for the steel. It usually takes under an hour and there is no charge.
Who approves steel beam installation in Gateshead?
Structural work in Gateshead needs a building notice or full plans application to Gateshead Council or a registered building control approver. We prepare and submit it with the structural engineer's calculations and arrange the inspections, so the completion paperwork follows the job.
Do I need a party wall agreement for steel beam installation in Gateshead?
Yes, if the beam bears into a shared wall: the Party Wall etc. Act 1996 applies in England and Wales, and a party structure notice must be served at least two months before that work starts. We arrange it through a party wall surveyor.